ide hard drive cloner

Factory is as the master disk, which is not required when only one hard drive is installed, but when multiple hard drives are installed, the hard drive jumper needs to be reset. The jumper on the hard disk is simpler, and the jum

BIOS setup hard drive mode, what does it mean to change the hard drive mode to IDE in BIOS? Our hard disk is divided into two kinds of interfaces, one is IDE, the other is SATA. Previo

The solution to the hard drive after computer boot: Just bought the computer boot ready to the hard disk partition install the operating system, but at this time, the problem arises, the machine to start self-test after the prompt can not find the hard disk In the beginning, I think it is the motherboard bios in the

Top 10 hard drive saving strategies In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. I.

connected. 3. Try reconfiguring the "PNP/PCI configuration" "Reset Configuration Data" in the BIOS to be set to "Enabled" using the BIOS options such as "Force Update ESCD", and then save the disk exit. If you can not start, try to set the "Disabled" to try. 4. Check the motherboard manual for CMOS jumper information and clear the CMOS. Please note that when you clear the CMOS settings, you must unplug the host power cable or set the host power switch to off or 0. 5. Disconnect the

drive connector line instability, hard disk physical damage. Processing method: One, CMOS caused by the fault The correct type of hard disk in the CMOS (that is, the BIOS system) directly affects the normal use of the hard disk. Today's machines support the "IDE Auto Det

How to see if the hard drive is recognized in the BIOS Generally plug in the hard drive data cable and hard drive power cord, and then boot into the BIOS, in the BIOS of the standard CMOS Features (standard CMOS feature set) here

SATA The full name of Sata is serial Advanced Technology Attachment,Proposed by Intel, IBM, Dell, APT, maxtor, and SeagateHard Disk InterfaceSpecification. The SATA hard drive adopts a new design structure, which features fast data transmission and space saving. It has many advantages over the IDE Hard

In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. Hard Disk not recognized by System The system cannot be started from the

In order to effectively save the data in the hard disk, in addition to regular backup work, we also need to learn how to save the hard disk when the hard disk fails, or extract useful data from the bad area, minimize the loss. I. Hard Disks are not recognized by the System The system cannot be started from the

remove the motherboard for observation, then found on the back of several places covered with dust, which is located in a IDE1 interface of the solder point, the accumulation of dust almost covered the solder. The dust 淸 clean, fixed the motherboard, fitted the accessories, restart the computer, successfully entered the Windows7 flagship version, everything back to normal. Note: Dust is the computer's invisible killer, the accumulation of dust hindered the heat dissipation, easy to damage comp

would invest $4.3 billion in cash plus stock to acquire a Hitachi wholly owned subsidiary, Hitachi Global Storage Technology (HGST), a world-class hard drive manufacturer. Hard Disk Interface Ata Full name Advanced Technology attachment, is the traditional 40-pin with the port data cable to connect the motherboard and har