ide hard drive cloner

the backup. When files are stored, they are written to contiguous blocks without fragmentation. This is a big job. It may be unnecessary for program partitions that do not change frequently like/usr, but it can create a miracle in the/home partition of a multi-user system. It takes the same time as the disk fragmentation of the Windows NT Server. If the disk performance is still unsatisfactory, there are many other steps to consider, but any hardware solution that includes upgrading or purchasi

condition. Now the PE in the toolbox comes with MHDD hard disk detection tool, it is important to note that in the motherboard BIOS check the hard disk mode, whether it is the AHCI mode or IDE mode, MHDD is unable to scan the hard drive in the case of AHCI mode Save

Test hard drive Bad Sectors in CentOS Hard Disk status testing tools: smartctl, Badblocks, hdparm You can quickly see whether the hard disk is healthy by using smartctl. The command is as follows: [Root @ qy ~] # Yum installsmartmontools-y Start SMART # Smartctl -- smart = on -- offlineauto = on -- saveauto = on/dev/sd

an idle disk. Do not write new data into the partition to be restored before restoration.This data recovery software supports FAT12, FAT16, FAT32, NTFS, and EXT2 file systems, find the files in the disk after the partition/partition table is damaged or the Ghost is damaged. for deleted files, the software has a unique algorithm to restore files that are considered unrecoverable, And the Directory and file recovery results are very good; it also supports recovery of various storage media, includ

function of the low grid, so the recommended or software to the way to the low-level format of the hard disk. Maxtor produced a low grid tool Low.exe, the software can be maxtor hard disk, in fact, this program can be applied to various brands of various models of IDE hard disk. The operation of the software is quite

Installation system can not find a hard drive solution First of all, we find the reason from the periphery, a hard drive to work first must have a power supply, there is an IDE line with the motherboard. Therefore, do not recognize the

disk. Here, root corresponds to/boot partition (if/boot partition is not specified separately, this root should point to the "/" partition ). Digression (basic knowledge supplement) Hdx, msdosy Hd specifies the hard disk, starting with 0. hd0 indicates the first hard disk, and so on. Msdos specifies the partition on a hard disk. Starting from 1, msdos1 indicates

, you can understand C:/Documents and Settings/Administrator/local in windows.Settings/TEMP directory. Pai_^7. Set the "mount point" by yourself"In Windows, we can use "create folder" to store a class of things, of course, in Linux. In addition to this method, you can also set a "MountLoad point "(in fact, the function is equivalent to setting up a special place to store special things ") There are many others. I will not elaborate on them one by one. The following figure shows the functions of

have built-in RAID features or has been in the BIOS to turn off RAID features, you can not load the driver, directly install the system. Scenario four: Some motherboards from the IDE to the SATA transition period, SATA is turned off by default in the BIOS. You need to manually enable the line. SATA interface: Serial ATA (SATA, serial Advanced Technology attachment), also known as Serial ATA, is the twin brother of serial SCSI (sas:serial attached S

the hard disk is usually set to Cable Select, which can be adjusted as needed. All devices connected to the channel must support the Cable Select function, and all devices connected to the channel must set the jumper to the Cable Select function. 4. If the hard disk uses sound insulation or shockproof insulator, use a taper or patch cord connection between the hard