netgear router connected but no internet

Steps/Methods 1. Using Broadband router Networking This content takes D-link DI-504 home broadband router As an example, talk about how to use the broadband router to share the Internet, as shown in Figure 2008112864. Figure 2008112864 DI-504 Home Broadband router The DI

With the switch without the router can share the Internet, I unit of the room more than 160 units are used on the switch, and any computer room can do a host of the first dial-up Internet, other machines are also able to access the Internet, Units of this broadband is LAN mode, is from the telecommunications of fiber

"Properties" 4. Double-click Internet Protocol version 4 (TCP/IP) 5, select "Automatically obtain IP address", "Automatically obtain DNS server address", click "OK"-"OK". 1, open the browser , enter in the browser address bar: 192.168.0.1 Press ENTER to login settings interface. 192.168.0.1 not open? Please click this link 2, in the Settings page sel

lines, cable modems, or wireless connections. The technology also simplifies the configuration of end users when selecting these services. Third, the implementation of PPP protocol on Ethernet, it uses Ethernet to make a large number of hosts network, through a remote access device to connect to the Internet, and access to each host control. Billing function, a very high performance price ratio so that PPPoE in the community including the constructi

2, (a light cat) to the light cat out of a network cable to connect the router's WAN (blue logo), and then find a short network cable, a computer, a router 1/2/3 arbitrary interface (yellow), wiring mode as shown below: Note: when powered on, the router is working normally with the SYS LEDs flashing, WAN LEDs illuminated steady or blinking, and the 1/2/3 port LEDs attached to the computer are illuminated s