built by the constructorVal SSC =NewStreamingContext (Conf, Seconds (5)) //push mode: Flume sends data to spark (note that the host and port here are streaming addresses and ports for others to send to this address)Val Flumestream =Flumeutils.createstream (SSC, host, port)//flume data in the Event.getbody () to get the real contentVal words = flumestream.flatmap (x =NewString (X.event.getbody (). Array
the permitted range.
Check the AC power supply of the specified power supply device. If the problem persists, see troubleshooting power supply device faults.
E1624
PS Redundancy
The power supply device subsystem is no longer redundant. If only the power supply device fails, the system will shut down.
See troubleshooting power supply device faults.
E1710
I/O channel CHK
The system BIOS has reported an I/O channel check error.
See for help.
E1711
The PCI bus defines two types of data transmission modes: posted and non-posted. Bus transactions using posted data transmission are also called posted bus transactions, while bus transactions using non-posted data transmission are also called non-posted bus transactions.
Posted bus transactionWhen the PCI master device transmits data to the PCI target device, w
Article title: FAQ about Nic settings in Linux (2 ). Linux is a technology channel of the IT lab in China. Includes basic categories such as desktop applications, Linux system management, kernel research, embedded systems, and open source.
4 NE1000/NE2000 Nic (and its compatible card) problems
Problem: No PCI NE2000 compatible Nic is detected when v2.0.x is enabled.
Cause: The ne. c driver before v2.0.30 only knows the
Http://www.mjmwired.net/kernel/Documentation/MSI-HOWTO.txt 1 The MSI Driver Guide HOWTO 2 Tom L. Nguyen Tom.l.nguyen[at ]intel[dot]com 3 10/03/2003 4 revised FEB 5 Martine 6 Revised June, by Tom L. Nguyen 7 8 1. About this guide 9 A guide describes the basics of message signaled interrupts (MSI), the advantages of using MS I over traditional interrupt mechanisms, and you to enable your driver to the use MSI or msi-x.
Also included is the Frequently asked Questions (FAQ) section. 1.1 Terminolo
);}
As shown in the preceding figure, NIO is a typical Reactor mode. It registers events of interest and scans for events of interest to perform relevant actions.
2. The key code on the server side is as follows:
ServerSocketChannel ssc = ServerSocketChannel. open (); ServerSocket serverSocket = ssc. socket (); // bind the port serverSocket to be listened on. bind (new InetSocketAddress (port);
under projectname/src/main/scala/.../, and if the code is built according to the above steps, it will be found at the end of the catalogMyRouteBuildMyRouteMainThese two files are module files, deleted MyRouteBuild , renamed MyRouteMain to DirectKafkaWordCount . Here, I use the spark streaming officially provided code for the instance code, the code is as followspackage Org. Apache. Spark. Examples. StreamingImport Kafka. Serializer. Stringdecoderimport org. Apache. Spark. Streaming. _import org
ASPnet mvc4 go
-- I admit that I am very lazy, but today I may be able to "meow" something
Original: ASP. net mvc 4 in action
I have limited ability. I try to concentrate on the knowledge in the book. After careful study, you will learn about the MVC Framework in other languages.
ASP. net mvc compared to webform, after completing chapter 1, you will find that the browser address bar is so concise and the file classification is so well maintained,
Without a master page, you can write fu
basically populated with different server controls as required.
Scoresettingcollection SSC = new Scoresettingcollection ();
Functioncollection FUNCC = new Functioncollection ();
FUNCC. Getinfobyfunctionname ("edition name Management");
int functionid=funcc[0].id;
SSc. Getspecialinfo (functionid,0,roletypeid,bbstypeid,-1,-1,-1,-1);
int SSCCOUNT=SSC. Coun
parameters directly at the command line.
After generating the private key and certificate, download the HTTPS proxy:
Go get github.com/ossrs/go-oryx/httpx-static
For Remark:golang settings, refer to the GO environment configuration.
Note: Detailed parameters can be run directly httpx-static program without parameters, will show help.
To start the service, agent to SRS Version:
sudo $GOPATH/bin/httpx-static-http 80-https 443 \
-proxy http://ossrs.net:1985/api/v1/versions \
-
How do I differentiate the solid-state drives of the M.2 interface?
M.2 is Intel led the development of a new generation of interface standards, with a smaller size, faster interface features, the current main specifications are the following, mainly the length is not the same.
The image below is a two-m.2 SSD:
The short one is the Shadow Armor War m.2 128GB
Long is the Shadow Armor War m.2 256GB
These two are m.2 interface, how to distinguish which is the
For their old computer purchased a AMD770 motherboard, replaced on the boot that appears black screen phenomenon. According to the merchant said this is a new motherboard, should not be a quality problem, perhaps due to improper BIOS settings. The system bar to try to explore in the bios of the motherboard many times, finally found the problem.
Open the Bois and enter the CHIPSET-NORTHBRIDGE-CONFIGURATION-PCI Express Configuration interface, which ha
I. Relationship between device management and file management
1. file operations are the organization and abstraction of device operations
Device operations are the final implementation of File Operations
Ii. Device Driver Model
1./sys -----> bus -----> PCI -----> driver -----> serial port -----> Device
2. Several main layers of the device driver model:
(1) bus, see linux2.6I/O Architecture
(2) PCI bus, s
This article only discusses the general Writing of network device drivers. The Code related to the hardware is omitted because of the different hardware specifications. Are there any mistakes or supplements? You are welcome to raise them.
1. Loading and uninstalling the driver module
If the network device (including wireless) is PCI compliant, first register the PCI device (pci_register_driver) with the ker
How to buy a notebook built-in wireless network card?
Wireless LANs are also known as WLANs. WLAN is the use of wireless technology in the air transmission data, voice and video signals. Its main purpose is to solve a small range of wiring problems and a new scheme. Say simple is from Adsl,lan and so on a variety of broadband access to the computer we use to achieve wireless transmission, it and we are familiar with CDMA and GPRS are two completely different ways of accessing the Internet (CDMA
Write a uhci bar, also miss Intel, as well as the Intel's several female colleagues, long time no contact, how are you?
UHCI was proposed by Intel. I've been away from Intel for over a year, but I've always felt like I'm going back to Intel one day. So I'm going to be a little concerned about Intel. I really miss Intel, though it's not much, but I just graduated. I didn't think much of the money problem.
UHCI Full Name Universal host Controller Interface, which is a USB host Controller interfac
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.