raspberry pi router vpn

0. Power supply is micro USB (Android power connector) 1. Download the operating system from the official website and write the memory card with Win32diskimager. 2. Locate the IP and set the static IP under the router: Command: sudo vi/etc/network/interfaces Switch Auto LoIface Lo inet LoopbackIface eth0 inet StaticAddress 192.168.1.88Netmask 255.255.255.0Gateway 192.168.1.1Allow-hotplug Wlan0Iface Wlan0 inet ManualWpa-roam/etc/wpa_supplicant/wpa_supp

(recommended)-l,–ignore-locks ignore locked state reported by the target APIgnore the locked status reported by the target AP-e,–eap-terminate terminate each WPS session with an EAP FAIL packetTerminates the WPS process whenever an EAP failure packet is received-n,–nack Target AP always sends a nack [Auto]Always send Nack to target AP, default auto-w,–win7 Mimic a Windows 7 registrar [False]Analog win7 registration, default offReference:Http://lok.me/a/1972.htmlHttp://bao3.blogspot.com/2013/05/

IP address based on the MAC address. Router Query MethodIf you have the permission to log on to a vro (such as a home network), you can directly query the IP address assigned by the vro to the access control card on the vro management interface. 2.2 front-end controller card reading display and uploading Log on to the front-end access control panel. The IP address of the access control panel is the IP address (192.168.20.106 in this example) found i

1, install the required packagesudo apt-get install Hostpad UHDCPD2. Configuring the/etc/network/interfaces FileConfigure Wlan0 as static addressThe format is as follows:Iface wlan0 inet StaticAddress 192.168.10.1Netmask 255.255.255.0Save, exit3. Configuring the/etc/udhcpd.conf FileSet up automatic assignment of address ranges for DNS gateways, etc.Specific as follows: (according to individual needs to configure)Start 192.168.10.2 # This is the range of IPs that the Hostspot would give to client

First, sign up for a NOIP account .Refer to this tutorial: http://www.cnblogs.com/infopi/p/3991407.htmlCreate a DirectoryLine 1th enters the current user's home directoryLine 2nd establishes the Noip subdirectory, line 3rd enters the Noip subdirectoryCD ~mkdir NoipCD NoipDownload Noip client source, installThe 1th line to download the source code, the 2nd line decompression source code, 3rd line into the extracted source directory4th line compilation, line 5th installationwget http://www.no-ip.c

sudo ifconfig eth0 192.168.1.212 netmask 255.255.255.0 (192 .... 212 is your bound ip,netmask is the subnet mask)sudo route add default GW 192.168.1.1 (this is your router, this is called Gateway)sudo ifconfig eth0 up (makes setup successful)Exception in your WordPress dashboard in the general settings in the regular URL to your domain name, as if it will be faster, I do not understand why, just know that this will be fast, you like this memory, chang