slave hard drive

disk access is not a problem, speed is also very fast, so the elimination of hard disk problems. That leaves only the hard drive jumper-a system that used to be a single hard drive, the hard

What to do if the computer doesn't recognize the hard drive: First check the hard drive master and subordinate line settings are set wrong, the master-slave line set incorrectly will cause the system can not be correctly identified. Test if the system can boot

a root, If it is not connected to the problem, then you look at the hard disk on the master-slave line is set correctly, how to set the status of the master and slave jumper will generally be on the hard disk on the tip, according to your own needs to set the hard disk as t

mentioned in this article. Computer does not recognize the hard drive solution: First check the hard drive master and subordinate line settings are set wrong, the master-slave line set incorrectly will cause the system can not be correctly identified.

further study it. ■ The partition cannot be opened, and the message "This partition is not formatted" is displayed" Fault: When a drive letter cannot be opened during normal use, the system prompts "This partition is not formatted" There is no doubt that direct re-formatting can solve the problem, so if there is no important file information in this partition, xiaobian strongly recommends that you directly format the

compatible with the PATA device by using a multi-purpose chipset or serial-parallel converter. Because SATA and PATA can use the same drive, you do not need to upgrade the operating system or perform other changes. 5. You do not need to set the jumper of the Master/Slave disk for Sata. The BIOS will number it in the order of 1, 2, and 3. This depends on the SATA connector to which the

) use DISKEDIT to call the second allocation table and use NDD to fix the problem. (For the download URL, see the end of the article)Procedure: start the computer with a floppy disk and run diskedit. In the drop-down menu of "Tools ",Select "Use the second FAT table", exit diskedit, run ndd, and select"Diagnose disk", step by step follow the prompts until the operation is completed.(4) display "disk boot failure, INSERT SYSTEM DISK AND PRESSENTER faultCause: (1) the

Test hard drive Bad Sectors in CentOS Hard Disk status testing tools: smartctl, Badblocks, hdparm You can quickly see whether the hard disk is healthy by using smartctl. The command is as follows: [Root @ qy ~] # Yum installsmartmontools-y Start SMART # Smartctl -- smart = on -- offlineauto = on -- saveauto = on/dev/sd

low-speed hub, the device may not be installed properly, as long as the connection line is replaced with a USB 2.0 standard to resolve the failure. Attention matters After you install the driver, you can view the removable hard drive from Device Manager, but there is no corresponding letter identifier in the resource manager, which is the result of improper system setup. Additional computer

1. The hard drive has bad track symptom A. When reading a file or running a program, the hard disk repeatedly read the disk and error, prompting the file damage information, or it will take a long time to succeed; sometimes even a blue screen B. ScanDisk scan disk error will be run automatically every time the system is powered on C. When the ho

When you start your computer, you do not see the Windows splash screen, but instead appear the "Non-system disk or disk Error,replace disk and press a key to reboot" (non-system disk or disk error) prompts, which is the common hard Disk failure-Unable to boot the system. (i) Hard failure causes hard drive to boot The

How to see if the hard drive is recognized in the BIOS Generally plug in the hard drive data cable and hard drive power cord, and then boot into the BIOS, in the BIOS of the standard CMOS Features (standard CMOS feature set) here