spi firewall

The ad7708 is a 16-bit Σ-△type adconverter chip. in low-frequency applications, the ad7708 can be used as the complete front end of a single power supply. The ad7708 contains a PGA (Programmable Gain Amplifier) to enlarge the signal. The PGA range is 20-28, which is programmable, when the reference voltage is V, the voltage from 20mv to 2.56v can be measured. The ad7708 and ad7718 pin functions exactly the same, but the number of digits ad7718 is 24 bits. If you use 7718, you only need to change

SPI (Serial peripheral Interface), serial Peripheral interface. SPI is a high-speed, full-duplex, synchronous communication bus.The SPI interface typically uses 4 lines of communication:Miso Master device data input, from device data outputMOSI Master device data output, from device data inputSCLK clock signal, with main device generatedCS from the device chip se

Principles, differences and Applications of SPI, I2C, and UART Serial Bus 1. UART is a two-line interface. One transmission and one receiving interface can communicate with each other in full duplex mode, and the number of lines is relatively small. Data is transmitted asynchronously, with strict timing requirements on both parties, and the communication speed is not fast. It is used most frequently for multi-host communication.2. Compared

The S3C2440 contains two serial peripheral device interfaces (SPI ports), each of which has two 8-shift register for sending and receiving, respectively, in one SPI communication, data is synchronously sent (in serial mode) and received (in serial mode ). The rate of 8-bit serial data is determined by the content of the relevant control register. If you only want to send data, some virtual data will be rece

1. IntroductionThe SPI full name is the service Provider Interface, the provider interface, the service usually refers to an interface or an abstract class, the service provider is a concrete implementation of this interface or abstract class, by the third party to implement the interface to provide specific services. SPI provides a dynamic mechanism for extending applications, often as an extension of the

1: Configure PIN for SPI function At the end of the board-mx6q_sabresd.h, the copy is redefined (To add SPI2 as an example) [CPP]View Plaincopy "FONT-SIZE:18PX;" > MX6Q_PAD_EIM_CS0__ECSPI2_SCLK, Mx6q_pad_eim_cs1__ecspi2_mosi, Mx6q_pad_eim_oe__ecspi2_miso, MX6Q_PAD_CSI0_DAT11__ECSPI2_SS0, After that, the board-level file BOARD-MX6Q_SABRESD.C will have related functions for the unified initialization

The abbreviation for the Serial Peripheral Interface (Serial peripheral interface,spi). is a high-speed, full-duplex, synchronous communication bus that occupies only four wires on the chip's pins. Motorola is first defined on its MC68HCXX series processors. The SPI interface is used primarily in eeprom,flash, real-time clocks, ad converters, and digital signal processors and digital signal decoders.The

The Serial Peripherals Interface (serial peripheral INTERFACE,SPI) is developed by Motorola to provide a low-cost, Easy-to-use interface between microcontrollers and peripheral chips (SPI is sometimes referred to as a 4-line interface). This interface can be used to connect memory, Ad/da converters, real-time clock calendars, LCD drives, sensors, audio chips, and even other processors. Currently, there are

The first difference is of course the name:SPI (serial peripheral interface: serial peripheral interface );I2C (Inter IC Bus)UART (Universal Asynchronous Receiver Transmitter: Universal asynchronous transceiver)Second, the difference lies in the electrical signal line:The SPI bus consists of three signal lines: sclk, SDO, and SDI ). The SPI bus allows multiple SPI