Previously did not feel what the use of fingerprints on the notebook, and later inadvertently saw the fingerprint can boot. Try to use this function. It was a bit of trouble.1, the official website does not have the WIN10 fingerprint application software.Download the version of Win8, no problem after installation, you can log in to win10 use.2, boot or to press the power button, can not do cold start.Need a computer power off, unplug the battery and power, and then plug it in. This time, we foun
I started with an X61s and restored the x61s OEM XP with one click ..We all know that Thinkpad comes with a lot of software... As a result, the TPM password problem of CCS (client security solution) occurs ..Prompt: "the Trusted Platform Module (TPM) on this system has been previously configured. You must use BIOS Setup Utility to clear TPM"I have never set a password, but I have never succeeded in setting a lot of default passwords. Every time I star
The X230 itself is a 2g memory, 32-bit system, after adding or subtracting memory strips, since the 32-bit system has a maximum memory of 4g, the system needs to be swapped to 64 bits.After the installation disk is engraved, install the system with an external optical drive. The process is not a table, only a few points to note:
The option to speak USB3 in the BIOS is switched from ' auto ' to ' disable ', otherwise the system fails, either the driver is not found or the Windows expansion
1, boot, press F1 into the BIOS, select Config--keyboard/mouse,2. In the change to "f1-f12 keys" option, the changes are set to legacy or default.? ? (where legacy mode means you can use the hotkey without holding down the FN key.)? ? The default mode indicates that you need to hold down the FN key when using a hotkey, and then press the corresponding function key. )3, press FN+F10 Save exitHow does the shortcut key for Lenovo ThinkPad E40 close? Whic
Failure phenomenon:
Lenovo Security Bulletin: LEN-5595
Potential impact: After running the Security cleanup utility, drive data may be restored.
Severity: Medium
Scope of Influence: Lenovo
Summary description:
The SanDisk firmware used to clear the data in these SSD does not conform to the specifications of Lenovo. It has been confirmed that, in some cases, the data in the affected SanDisk drive may be restored, even after running the ThinkPad D
Hinkpad E550 Machine, in the power options, set to 1 minutes to turn off the monitor, as shown in the following illustration:
Then normally use a Web page or player to play music for a period of time after the screen is closed, the concert has a noise or a Carrington.
The replacement of the motherboard and speaker is not valid, as is the speaker or headset playback effect.
Impact Model: ThinkPad E550 machine with JBL Horn, graphi
Fault symptom:ThinkPad S1 Yoga 12 may display a black screen when the system is booted to the system interface after the system is upgraded to Win10 H2.Impact scope:-Applicable model: ThinkPad S1 Yoga 12-Applicable operating system: Windows 10 H2.Solution:In case of this problem, use Windows Update to Update the patch KB3140743.Temporary solution:If you encounter this problem, please touch the screen to display it normally. However, this problem may o
Fault symptom:The Fn and Ctrl functions of ThinkPad notebook can be set in the BIOS to meet different usage habits. In actual situations, after the E440 is set, the switching function cannot be implemented, for example, Fn + c cannot implement the replication function.Solution:This problem is caused by BIOS files,Update BIOS to 2.16.
Tip: back up important data in advance before the operation.1. Prepare the created recovery USB flash drive;2. Insert the USB flash drive into the USB port on the left side of thinkpad 10, press and hold the enable key + volume reduction (press and hold volume reduction during restart) to enter the boot menu;And select the USB flash drive to start3. Select a language;4. Select the keyboard layout;5. Select "Troubleshooting ";6. Select "
I just started ThinkPad l440. It's quite good to use. Hey, hey! The l440 system default (F1-F12) keyboard is the system default function key, mainly controls the volume, brightness, connection projector and so on. Because programming requires debugging, frequent use of F10, F11 and other keys, but by default these keys are system function keys, to press FN + (F1-F12) key can be achieved (F1-F12) function, it is quite troublesome to use. I have read ma
ThinkPad x220i Win7 System, because the system is very card and has previous colleagues left behind the data, so think of using Lenovo Rcovery restore factory settings, Unfortunately the picture is always good. 1, restart Press F1, select "Repair Computer" and did not find Lenovo factory recovery. 650) this.width=650; "Src=" https://s4.51cto.com/wyfs02/M01/A7/08/wKioL1nfYBCxd7zLAAmf0Vl6Ngg122.png-wh_500x0-wm_ 3-wmp_4-s_3617760942.png "title=" Pic-004.
About the mouse
The Lenovo Bluetooth laser mouse is a small Bluetooth mouse in the typical ThinkPad-design. Lenovo partnumber is 41u5008.Technical Specifications
Three buttons
Scrollwheel with tilt-Functions
Infrared Laser
800 DPI
Using the mouse with Linux
The first time you are using the mouse it has to be written red with your computer. Switch the mouse on, press the button next to the power-switch and use the following command to connect it:
Fault description:
After the Linux system is installed on the Thinkpad T43 notebook, "Access IBM" may fail to boot the system to restore the partition, and the error "missing operating system" may be prompted ".
Solution:
If the restored partition is still stored on the hard disk, it can still be accessed. After Linux is installed, restore the partition to a hidden inactive partition, which is why it cannot be started. If the system is a dual-boot, Bo
Http://ubuntuforums.org/showthread.php? T = 2190347
Body:
The wireless network adapter cannot be used after the Thinkpad Edge E440 is installed with Ubuntu12.04. You need to manually install the driver.
Download the driver's original code for compilation and installation:
Sudo apt-get install build-essential linux-headers-generic
Download: http://netbook-remix.archive.canonical.com/updates/pool/public/o/oem-wireless-rtl-92ce-92se-92de-8723ae-
When you find that the laptop is restored from the standby mode, the screen brightness becomes low, even if you adjust the brightness, It is very low and the brightness is not normal. The solution is to unplug the power and re-plug the power to restore the brightness. Of course, I used to restart my computer.
However, sometimes it will not decrease. Why? You can do this experiment: In the standby mode, there are plug-in sources and no plug-in power points in the notebook, plug-in power stands f
LSC the Intel HD Graphics 520 math test (mathematical Operations test) project will have an error, as shown in the following figure:
Impact of the product: ThinkPad
Impact of the series: E460, E560
Configuration of impact: Intel HD Graphics 520
Solution:
Please upgrade the Intel graphics driver higher than version 10.18.15.4279
Activate the process as shown in the figure.
It needs to be activated within 6 months of WIN10 activation, which is conditionally restricted.
Open the pop-up activation window as shown in the figure
Click on Lenovo Exchange, as shown in the following figure.
Then we log in using our own micro-mail account.
In this country we definitely choose Chinese to understand and use simple Chinese.
Then set it up and wait for activation
In this article, the testing model is ThinkPad S5, and the Windows 10 and 64-bit professional systems are pre-installed. When the Word and QQ software are enabled, the testing results are for reference only. The actual use time will be different from that of the background program, the screen brightness is directly affected.1. Set power options:Right-click the power icon, select power options or right-click in the lower left corner of the desktop, and
The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion;
products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the
content of the page makes you feel confusing, please write us an email, we will handle the problem
within 5 days after receiving your email.
If you find any instances of plagiarism from the community, please send an email to:
info-contact@alibabacloud.com
and provide relevant evidence. A staff member will contact you within 5 working days.