. Net MF series Directory: http://www.cnblogs.com/lscy/archive/2012/08/23/2651768.html
Companion article: Explorer 2 firmware brush description http://bbs.53wb.com/forum.php? MoD = viewthread & tid = 237 & fromuid = 47
I. Firmware Introduction
Explorer 1 firmware: tinyclr. Bin (download not supported currently)
For. Net MF transplantation and related information, please contact @
2. Prepare tools
Deployment software: yfaccessflash
USB fangtou Cable
USB => RS232
3. Hands-on operations
Reference: mftinybooter_deploy.pdf
1. Set the Startup Mode of the Development Board
Set the opening board to system_boot (ISP) mode. There are jp8 and jp9 at the bottom of the Development Board, and there is a patch cap. Connect the two needles on the left of jp8 with the patch cap, and jp9 connect the two right pins with the patch cap. Restart the Development Board and enter ISP mode.
2. Firmware Installation
Enable yfaccessflash software, initial software status
On the top of the page, com5 is connected to USB => 232 on my computer. Click
If you do not read it once, you can try again after the mouse pointer returns to normal state.
The general partition has been known.
The red box is the read firmware, and the blue box is the firmware to be installed on the local machine.
First erase the original firmware
Prepare for Installation
Click write to download the current firmware. After the firmware is successfully installed, check the firmware to check whether any error occurs during the installation.
Please be patient.
Burned successfully. Next, perform the verification.
Please be patient
Verification Successful.
When an error occurs in one of the steps, try again. If the problem persists, the Development Board will be powered off and restarted. Restore the development to the flash_boot mode and reset the Development Board. Success.
If you have also installed the firmware, remember the firmware and wait for me to tell you.
Related Resources:
1. QQ group: 1600838. 2. Blog: http://www.cnblogs.com/nnhy/ 3. Forum: http://www.53wb.com/