192.168.1.1 Login Router does not eject login box

First, if the user is through IE browser to enter the URL landing router, then it may be with IE whether the agent has a relationship, if the IE set the agent, it will appear above the fault, all first we cancel the proxy settings. Click "Tools-internet Options-connect-LAN Settings" as shown in the picture:

Second, after the cancellation of the agent and then check whether the computer and the La interface (generally there are 4 interfaces, one of the 4 excuses of the interface) number, and then see if the router is working properly, the LED is not lit.

Third, of course, some users are dial-up Internet access through the modem. If this is the case, remove the broadband dial-up connection first. Select "Never dial Connection" specific steps: Click on the IE browser toolbar above the "Tool-internet options", switch to the "Connect" button, you can operate as shown in the following image:

Four, again check the user's local address set IP address and router LAN port IP belong to the same network segment, if not the same network segment, you can manually configure an IP address. If it is not set, set to the "Automatically get IP address" setting. Locate the local Area Connection in turn, right-click to select Properties, and then double-click Internet Protocol version 4.0 to set up. As shown in the figure:

V. After the above operation, now try to enter 192.168 in the address bar of IE browser. 1.1来 into the router's setup interface. If the landing is not entered, then the router can be reset, restore the initial state.

Six, and finally modify the management of the router port, then login should enter Http://LAN Port IP: port number.