6000EV/6005HW ADSL Modem Set port mapping

In the main menu midpoint "Nat", there will be a "NAT channel list" To install the Web server on the internal PC 192.168.1.2 as an example, the general default port for the Web is 80, set as follows: In the NAT channel list

Mupltiple Port forwarding fill in the following content:

Action:add

Channel N1

Protocol:tcp

Incoming port, begin:80, end:80

New Port begin:80,end:80

New IP address:192.168.1.2.

Set port mappings in the LINKSYS ADSL router:

In the main Menu "advanced", the next menu has a "forwarding" to install the Web server on the internal PC 192.168.1.2 as an example, the general default port for the Web is 80, set as follows:

EXTPORT:80 to 80

IP address:192.168.1.2

and click "Apply" to do it.

Set port mappings in broadband Blue elf routers:

Under the Advanced Settings page, click Distributed Servers Setup (virtual serves, hosting settings).

Each virtual Server is defined as a service port, and all access to the port is redirected to the corresponding service IP computer.

For example, if you want to:

Set up an FTP server on the computer 192.168.123.10. (Port 21)

An SMTP server that has an email installed on the computer 192.168.123.20. (Port 25)

Set up a Web server on a computer 192.168.123.30. (Port 80)

Erect a POP server on the computer 192.168.123.40. (Port 110)

Then you need to set this page as follows:

Service Service Port Service IP Enable

FTP 21 192.168.123.10√

Email 25 192.168.123.20√

WEB 80 192.168.123.30√

Post Office 110 192.168.123.40√