A comprehensive introduction to Common commands in the Huawei vswitch configuration Manual

This section provides a comprehensive overview of Common commands in the Huawei vswitch configuration manual, you can use the IOS command in the Huawei Switch configuration manual to explain this document. This allows you to focus more on different ATM sub-interfaces.

The Huawei Switch configuration manual configures each LEC to a different ATM sub-interface. The command is as follows:
ATM (config) # interface atm number. subint multipoint
ATM (config) # lane client ethernet vlan-num elan-num

Show lane server is used in the Huawei Switch configuration manual to display the LES status.

In the Huawei Switch configuration manual, show lane bus displays the status of the bus.

Show lane database is used in the Huawei Switch configuration manual to display the LECS database content.

Show lane client is used to display the LEC status in the Huawei Switch configuration manual.

In the Huawei Switch configuration manual, use show module to display the list of installed modules.

The Huawei Switch configuration manual uses physical interfaces to establish a connection to a VLAN:
Router # configure terminal
Router (config) # interface media module/port
Router (config-if) # description-string
Router (config-if) # ip address ip-addr subnet-mask
Router (config-if) # no shutdown

The Huawei Switch configuration manual uses a relay link to establish a connection to a VLAN:
Router (config) # interface module/port. subinterface
Router (config-ig) # encapsulation [isl | dotlq] vlan-number
Router (config-if) # ip address ip-address subnet-mask

The Huawei Switch configuration manual uses LANE to establish a connection to a VLAN:
Router (config) # interface atm module/port
Router (config-if) # no ip address
Router (config-if) # atm pvc 1 0 5 qsaal
Router (config-if) # atm pvc 2 0 16 ilni
Router (config-if) # interface atm module/port. subinterface multipoint
Router (config-if) # ip address ip-address subnet-mask
Router (config-if) # lane client ethernet elan-num
Router (config-if) # interface atm module/port. subinterface multipoint
Router (config-if) # ip address ip-address subnet-name
Router (config-if) # lane client ethernet elan-name
Router (config-if )#...

To perform dynamic routing configuration on the Route Processor, you can use the IOS command in the Huawei Switch configuration manual:
Router (config) # ip routing
Router (config) # router ip-routing-protocol
Router (config-router) # network ip-network-number
Router (config-router) # network ip-network-number