About network settings for Win7 and virtual machine Linux Interoperability Ping

Http://www.linuxidc.com/Linux/2014-04/100450.htm

Although from WinXP to Win7 have been able to use the VMware Virtual machine installed Linux system, remember every time about the Windows and Linux network setup problems, need to find relevant reference in Baidu, many times after the toss to achieve, The same work takes a lot of time and effort every time, and the worst is that after a while, the successful implementation of interoperability settings will be forgotten. The so-called good experience, although at the time always thought that they have been completely understood for the set-up steps, and it does not seem surprising that the simple, but in the absence of records and forgotten, will remember the original is so complex. Because of the momentary so-called contempt and laziness leading to repetition, two times, ... A lot of wasted energy to start from scratch, absolutely can not tolerate so. Therefore, after today's successful implementation of the interoperability set up, but also to keep their own experience to record.

Because it is to give yourself later as a technical setting reference, so what is said only oneself think is correct, for can not determine the principle details of things, do not speculate.

First, we'll show you how to set up a Linux network in VMware. The general network options are bridged, NAT, host-only several. This time with my implementation of the host-only as a sample to do a detailed explanation, such as:

After selecting Host-only mode, open the Network Properties edit window of VMware and you can see that the VMnet1 NIC is already visible.

Here VMnet1 can be set subnet IP is 192.168.0.0, mask is 255.255.255.0.

With regard to DHCP options, this can be done here, because I configure a static IP on a Linux virtual machine using YaST, such as: 192.168.0.222 (Note: This static IP address must be on the same network segment as the IP address set on subnet),

Regarding the NAT setting in the options, I have set the gateway IP address to 192.168.0.1 in strict accordance with the recommendations on the network (in fact, I also tried to use the 192.168.0.* any IP, as long as the host and the Linux virtual machine IP conflicts, no problem). Such as

Basically, the configuration of the above VMware virtual machines is done, and the Linux-side network configuration based on Host-only mode is available.

Then configure the new network interface card VMNET1 on the Windows local machine. Here also just set its IP address to 192.168.0.2 (must be in the same network segment as the previous subnet IP). Such as:

At this point, the network setup between the Windows native and the Linux virtual machine is complete.

Of course, only the above settings, may not be guaranteed to achieve Windows and Linux ping interoperability issues. This involves both sides of the firewall problem.

About network settings for Win7 and virtual machine Linux Interoperability Ping