About WIN10 creating WiFi hotspot issues

Computer to create WiFi, generally three ways:

1. WiFi sharing software: Cheetah WiFi, WiFi sharing wizard, WiFi sharing guru .....

2. Command prompt

Netsh wlan set hostednetwork mode=allow ssid=wifiname key=123456netsh wlan start hostednetwork

You can enter the above command by opening the cmd window. You can also save the above command as a bat and run it directly.

In this way, you typically need to open network and Sharing Center-change adapter settings-Set the local link share to the WiFi connection you just created (name Wifiname)

3. Win10 comes with mobile hotspot feature-but!!! Attention!!! : This method does not apply when your computer is connected to a broadband connection . The mobile hotspot cannot be opened at that time, and it will appear as shown on the right.

In addition to the problem, there is a problem:

Unable to start the hosted network, the status of the group or resource is not the correct state to perform the request operation

Solve:

Open a command prompt, enter

Netsh wlan show drivers

Check the network card driver support, find a line of "supported Bearer Network": if no, such as

Causes for the above reasons:

Usually use the Driver wizard and other software updates the wireless network card driver, because WIN10 system some wireless network card can not use the latest version of the driver, to install Win7 or WIN8 system under the old version of the driver to normally open WiFi, Therefore, users using WIN10 are not recommended to use the Driver Wizard software update Wireless card driver.

Workaround: Simply say roll back to the old wireless card driver

1. Right-click "This Computer", "Management", "Device Manager", "Network adapter" found wireless network card, the general name with Wireless, BGN,/b/g/g, 802.11, wireless These keywords is the wireless network card.

2. Right-click the wireless card and click Update Driver. Proceed as follows,

3. Finally install each of these optional drivers to try (click Next install), install a WiFi sharing big software to open WiFi test, until no longer prompted the wireless network card does not support the host until then. or with

Netsh wlan show drivers this command

4. If all the old drivers are not supported after installation, go to the notebook's official website to download Win7 or WIN8 version of the Wireless Card driver manual installation (preferably before the installation of the first uninstall of the previous driver), priority to download win7 version, if there is no win7 in the download Win8.

5. Really not, you can use the driver management software, to roll back the drive, I use Driver Booster

For any questions about this, you can contact Qq:2 .....

Forget it, comment area message

Reference Link: http://wifi.ggsafe.com/articles/20150820073323279.shtml Dengdeng

About WIN10 creating WiFi hotspot issues