Allows update of RIP unicast messages.

Source: Internet
Author: User

Because RIP is usually a broadcast protocol, to update the RIP Router to a non-broadcast network, the Cisco IOS software should be set to allow route information exchange between the two. To do this, run the following command in vro configuration mode:

To control a group of interfaces and exchange router update information with them, you must set the passive interface command to invalidate the sending of Route updates on the specified interface.

Related Articles]

  • Support for dial-up networks in RIP-2
  • RIP routing protocol and working principle
  • How to configure authentication for OSPF Dynamic Routing Protocol

Contact Us

The content source of this page is from Internet, which doesn't represent Alibaba Cloud's opinion; products and services mentioned on that page don't have any relationship with Alibaba Cloud. If the content of the page makes you feel confusing, please write us an email, we will handle the problem within 5 days after receiving your email.

If you find any instances of plagiarism from the community, please send an email to: info-contact@alibabacloud.com and provide relevant evidence. A staff member will contact you within 5 working days.

A Free Trial That Lets You Build Big!

Start building with 50+ products and up to 12 months usage for Elastic Compute Service

  • Sales Support

    1 on 1 presale consultation

  • After-Sales Support

    24/7 Technical Support 6 Free Tickets per Quarter Faster Response

  • Alibaba Cloud offers highly flexible support services tailored to meet your exact needs.