Analog switches and PCs in GNS3

A. target: Use the iOS c3640 switching module to simulate the switch

two. analog pc with VPCS

VPCS analog pc software download: http://down.51cto.com/data/195524

Step 1: Start the GNS3 software (this is not nonsense, hehe ...) ）

2. Click Edit---> Icon Management, the following dialog box appears

3. Follow the steps set in the diagram to complete the switch configuration

4. After step 3 is complete, at the bottom of the node type, a switch icon appears indicating that the add switch succeeded

5. Add two switches into the topology, because the switch is simulated with the router's iOS, so the icon is displayed as R1,R2,

Simply right-click on the R1 or R2 to change the device name, as shown in

6. Double-click R1 in the Topology and the Node Configuration dialog box appears as follows

2. Double-click the SW1 icon to open the following dialog box, set

3. Click OK to complete the following dialog box

4. When you have finished adding the switch, click Connect, as

5. Connect two switches, such as

6. When the connection is complete, exit the connection mode and the mouse pointer returns to normal, as

7. Right-click on the SW1 and select Console to enter the switch configuration

start the configuration interface as follows :

To successfully simulate the switch, the following VPC is used to add Virtual PC ...

8. Adding a Virtual PC method is similar to adding a switch, click on the Edit menu and select the Icon management option settings such as

9. Add two PCs to the topology diagram, such as

Double-click C1 to enter the node configuration mode as set

Double-click C2 to enter the node configuration

17.

2. after setting the C1 and C2, use the manual connection method to connect C1 and SW1,C2 and SW2 respectively, as

3. After completing the above steps, the topology diagram is completed, and the download vpcs is started below .

, Analog PC, the first run interface is as follows:

4. Use the show command to view relevant information

5. Configure IP addresses for PC1 and PC2, respectively, using the IP command, as

6. Note that the switch must also be configured before the connectivity test because the switch we are using is not a real switch, it is a switch that is emulated with a router, so the router's routing function is turned off and configured as:

(The configuration on SW2 is exactly the same as the SW1, not listed here.)

The final topological diagram of the experiment is as follows :

From for notes (Wiz)

Analog switches and PCs in GNS3