Analysis of D-LINK Switch configuration: graphic aggregation port detailed setting steps

Analysis of D-LINK Switch configuration: graphic aggregation port detailed setting steps, on the D-LINK Switch configuration in the port aggregation operation, the following gives a detailed illustration. This includes entering the configuration page from the web page and adding an aggregation group through the add button.

This article guides you how to configure the D-LINK switch port aggregation operation. As shown in:

 

D-LINK Switch configuration for port Aggregation

Enter the device D-LINK Switch configuration page from the Web interface, click configuration to see the following interface:

 

D-LINK Switch configuration for web Interface

Click Add to Add an aggregation group, for example:

 

D-LINK Switch configuration under the add button

Set Group ID to 1;
GroupName input dunk,
Select Enable for State,
Select static for Type,
The Master Port and Member Unit options remain unchanged. In PortMap, select 1 and 2 as members of the aggregation group, and click Apply to complete the settings.

◆ At this time PC1 and PC2 PING each other can not pass, need to perform the same aggregation configuration on the DES-3226S, the configuration interface and the DGS-3312SR is the same.

◆ Two D-LINK switch after configuration, two PCs can PING. In this case, you can use the layer-2 monitoring and statistics function to view the data traffic of members of the aggregation group. You will find that the traffic is always sent from one of the ports without load balancing. This is because the aggregation of 3226S does not support Server Load balancer.

◆ Unplug any of the Network cables. Observe the ports of the members of the aggregation group. The communication is normal, but the port of the unplugged network cable is invalid.

◆ After completing the above experiment, you can perform ports trunking across vswitches in the stack group to route PORTS of different vswitches in the stack group to the same VLAN.

Conclusion: Ports trunking technology is mainly used to increase the link bandwidth because it combines several Ports into a logical port. Therefore, when increasing the bandwidth, no loop is formed.