The H3C terminal Console analyzes the so-called terminal Console. It simulates the terminal into the router and configures the router. 1. The steps are as follows: www.2cto.com Router # configure terminal (entering configuration mode) Router # line con 0 (entering console configuration) In line con configuration mode, you can set the timeout time for idle time to exit the console, such as timeout and password. 1. TTY line, Cisco router asynchronous port, remote computer, Macintosh or UNIX host access through MODEM dialing. Router # configure terminal (entering the configuration mode) Router # line tty line-number [ending-line-number] (entering the tty configuration) Here you can set the user name for dialing, password and other security access control. Www.2cto.com 2. VTY lines, corresponding synchronization ports, such as Ethernet, serial, Token Ring, and FDDI interfaces, are accessed through Telnet. Router # configure terminal (entering configuration mode) Router # line vty line-number [ending-line-number] (entering vty configuration) ending-line-number is the last vty number. it indicates that several telnet connections are allowed at the same time. router # exec-timeout minutes [seconds] sets the idle timeout time and exits telnet access. 3. the SNMP-based network management protocol is specified on the vro. All Network Software Based on SNMP can manage the vro. Router # snmp-server community string [view-name] [ro | rw] [number] vty: virtual terminal typetty: tele terminal type