In fact, many vro configuration commands are similar, as is the same for Cisco vro configuration commands. Common users may not know much about Cisco vro configuration commands. during use, it only makes some simple configurations, but this will affect network security. Next we will analyze the Cisco router configuration commands in detail.
No vpdn logging
Vpdn-group pppoe <= started the vpdn process for PPPoE
Request-dialin
Protocol pppoe <= set the dialing protocol to PPPoE
Interface FastEthernet0
Ip address 192.168.0.1 255.255.255.0
Ip nat inside
Interface ATM0 <= set the ADSL Port
No ip address <= do not set the address
No atm ilmi-keepalive
Bundle-enable
Dsl operating-mode auto
Hold-queue 224 in
Interface ATM 0.1 point-to-point
Pvc 8/35
Pppoe-client dial-pool-number 1
Interface Dialer1
Ip mtu 1492 <= Modify mtu value to apply to ADSL Network
Ip nat outside <= Enable NAT translation. Set this port to an external network.
Encapsulation ppp <= use the PPP frame format
Dialer pool 1
Ppp authentication pap callin <= sets the dialing verification method to pap.
Ppp pap sent vip pass vip <= user name and password for sending
Ip nat inside source list 1 interface Dialer1 overload
Ip classless
Ip route 0.0.0.0 0.0.0.0 dialer1
No ip http server
Access-list 1 permit 10.92.1.0 0.0.255