Basic usage of IPMI

The Ipmitool–i Open Sensor List command obtains various monitoring values in the sensor and monitoring thresholds for this value, including (CPU temperature, voltage, fan speed, power modulation module temperature, supply voltage, etc.)
Ipmitool–i Open sensor get "cpu0temp" can get the ID cpu0temp monitoring value, Cpu0temp is the sensor ID, the server is different, the ID representation is also different.
Ipmitool–i Open Sensor Thresh sets the various limit values for the monitoring entry with ID value equal to ID.
Ipmitool–i Open Chassis Status View chassis status, including chassis power information, chassis operating status, etc.
Ipmitool–i Open Chassis Restart_cause View the reason for the last system restart
Ipmitool–i Open Chassis policy list to view supported chassis power-related policies.
Ipmitool–i open chassis power on to start the chassis, with this command can be remotely powered on
Ipmitool–i Open chassis power off chassis, use this command to remotely boot
Ipmitool–i Open Chassis Power Reset implements a hard reboot with this command to remotely boot
IPMI can also set up a system boot boot device, see the Ipmitool Help documentation for details.
Ipmitool–i Open MC Reset causes the BMC to restart hard
Ipmitool–i Open MC Info view BMC Hardware Information
Ipmitool–i Open MC getenables List all allowed options for BMC
Ipmitool–i Open MC Setenables Sets the appropriate allow/disable options for the BMC.
Ipmitool-i Open Event 1 sends an excessively high-temperature message to the system event log, the event that can be sent is:
1 Temperature:upper critical:going High
2 Voltage threshold:lower critical:going Low
3 memory:correctable ECC Error detected
The Ipmitool-i Open event command can be configured with a test to configure whether the SNMP functionality in IPMI is successful.
Ipmitool-i Open LAN Print 1 prints the current channel 1 information.
Ipmitool-i Open LAN Set 1 ipaddr 10.10.113.95 sets the address of Channel 1 to 10.10.113.95
Ipmitool-i Open LAN Set 1 netmask 255.255.255.0 setting subnet mask
Ipmitool-i Open LAN Set 1 DEFGW ipaddr 10.12.170.254 set Gateway
Ipmitool-i Open LAN Set 1 SNMP public setting community on Channel 1 is public.
Ipmitool-i Open LAN Set 1 access on Set Channel 1 allows access.
Ipmitool-i Open PEF Info print platform Event Filtering (PEF) information
Ipmitool-i Open PEF Status View platform Event Filtering (PEF) state
Ipmitool-i Open PEF Policies View Platform Event Filtering (PEF) policy settings
The Ipmitool-i open SDR list Fru reads the FRU information and displays it. (There is a problem with my server, the item cannot be read)
Note:
PEF is set by the BMC vendor's firmware, Ipmitool (V1.8.8) cannot be set up, or it can be initialized with Ipmiutil.

Basic usage of IPMI