benz-c180 Automatic file

a , input data
1.CAN Bus Description: Position, color, speed, bus type
1) Location: OBD 2) Color: 3) Rate: 500k 4) Bus type: HSCAN 5) test time: 2016.3.31

2. Vehicle characteristics
1) Displacement: 1.5L 2) configuration: Without a key to start 3) Transmission: Manual 4) whether the remote control on the response: no response to enter the remote control 5) No engine anti-theft 6) whether there is anti-theft alarm: No

No engine anti-theft, remote lock to start the vehicle, remote lock can not drive.

No need to step on the clutch to start
3. Door-side data, off open and close to activate can data

No
The doors are all closed.
Main door open
Left rear Open
Right rear Open
Right Front Open
Open the trunk.

Ago
4. Braking data
Brake Lift Up
Brake, step down.
Just hit on the file to detect if there are any data changes.

On off data
5. Engine speed
Speed linear proportional =1
Stalled
Just on off
On power on the data, stepping on the throttle data
Note that the data is normal after hitting d.
On file
Startup success (if there is no speed data, only the boot is a successful mark, the following three items are logged)
is starting
Off
6. Speed data attention to the on-file instantaneous data, and some models hit on the file instantaneous will become 0XFF, this data to shield it off
Static

7km later becomes 80

Proportional relationship *10

After the stall
On power-on data
7. Key action the best data in an ID, if the data is not an ID, consider on with the boot in an ID
Off file
Keyin
ACC File
On file a
St Gear
If the ON,ACC data is not found below the data on is updated, on close stop update, can be used as on reference data.
8. Remote identification according to the original car remote control instantaneous out of the data, the data changes corresponding instructions for the relevant unlock or lock press.
Remote lock
Remote lock
Lock unlock in the car
Locked lock in the car
9. Lock status Identify the state of the car lock after locking and after the lock change. Also note that there is no change when both on and the door are opened.
Locked lock in the car
Lock unlock in the car
Lock, then hit on.
Lock back door open
9a. Anti-theft data This data indicates whether the car enters the anti-theft state, also as the lock status of the cue data.
After the remote lock
After the remote lock
Lock the remote and hit the on file.
Remote Lock door Open
10. Clutch signal only manual vehicles require this data
Clutch Lift Up
Clutch step down
11. Light data light data to be updated in the off, and can bus stop to activate before the line, encountered the original car remote control can turn off the headlights, but we do not switch off the headlights of the case need to use.
P-File

P1 file

Automatic file
Small light File
Headlight Open
12. Gear position (not normally used)
P
In the Rail
R
N
D
M
13. Handbrake signal (usually not used)
Hand Brake lift up
Hand brake down.

14. Current Test and other conditions

15. Wiper Speed Detection

Close the file

Automatic slow file

Automatic Fast File

1 gears

2 Gears

Static

Shaved 1 times

Medium speed

High speed

16. Steering Wheel Angle detection

Left-most

Right-most

Middle

The right side turns on and starts to light

The left position starts to light

Right High speed angle

Left

17. Front and rear position detection of the main driving seat

No

18. Front-facing radar status detection

No

19. Start-Stop system status detection

Start and stop function open

Start-stop function off

After shutting down, the restart will open

On open

On off

20. Glass

Main door glass down to the end, 46 04 effective

Main door glass rising to the top

Sub-door glass drop Bottom

Secondary door lift Top

Left and then down to the end

Left rear lift Top

Right rear bottom down

Right rear lift Top

Skylight off.

Tilt up

Open to Maximum

The above data small end mode,

21. Mileage

10*

22. Alarms

, 1 for Alarm

Hit the on file.

Second, output data

1. Window (including skylight) output Note If power supply is required?
2. Down-Window output
Unlock output at 3.ON
Lock output at 4.ON
Unlock output at 5.OFF
Lock output at 6.OFF
7.OFF at the moment after the lock two minutes, whether it can unlock into the security state can unlock?
8. Trunk Output
9. Door side output of main door
10. Turn signal output (left, right)

11. Speaker output

12. Mirror Folding

13. Right rear view mirror turn down

14. The main car seat before and after the position output.

No

15. Front-mounted radar switch output

16. Start-Stop system switch output

Unable to bus output

benz-c180 Automatic file