Bluetooth Serial Module Common configuration (LC-05, BC-04, etc.)

In the Ding-Ding serial assistant   do not need to add/r/n on the hot atom, or Tao Common serial assistant, you need to add/r/n lc-05 module configuration when you need at + command directly after the parameter eg:at+namelibobc-04 module configuration Requires an at + command followed by the equals sign "=" in the parameter Eg:at+name = libo  General configuration requires only the following command to   configure the KEY Pin Connect module power supply (module voltage 3.3V) after configuration, key regardless, floating can, directly connected to the power supply, the module can work normally.   One, a single module configuration, such as communication with the mobile phone, three configuration is enough (for LC-05)  1, at+name = balance_car   Change the name 2, at+pswd = 0000 Change the pairing code 3, At+uart = 115200,0,0       change baud rate 1152004, at+role = 0 change from mode, 0 bit slave mode (default), 1-bit main mode  5, other default can   two, Two modules automatic connection configuration (for LC-05)  1, at+name = balance_car   Change Name 2, at+pswd = 0000 Change the pairing code (two modules to the same pairing code) 3, At+uart = 115200,0,0 & nbsp     Change baud rate 115200 4, At+role = 1 change from mode, 0-bit slave mode (default), 1-bit main Mode 5, At+role = 11 change main mode, 0-bit slave mode (default), 1-bit main mode  6, at+ ADDR reads the connection address of two modules (eg: if read from module 2013:123:000) 7, At+addr reads the connection address of two modules (eg: if the main module reads 2013:123:111)  8, At+bind = 2013,123,111       Send the address from the module, bind the main module (colon to English comma) 9, At+bind = 2013,123,000       to the main module, Bind from the address of the module (colon to English comma)  10, At+cmode = 0 is set to the specified address connection mode (0), the main module is preferably configured to 0, 1 means noSpecify the address connection 11, At+cmode = 0 is set to the specified address connection mode, from the module can be configured to 1, can also be configured to 0  so two modules are bound to each other, after the restart can be automatically connected (can be bidirectional communication)

Bluetooth Serial Module Common configuration (LC-05, BC-04, etc.)