Cacti adds bandwidth aggregation for multiple hosts

Previously I wrote a cacti add host bandwidth monitoring blog, you can refer to the http://blog.csdn.net/dai451954706/article/details/35272465, sometimes in order to facilitate O & M personnel to see the total bandwidth of the same machine room, need to make a convergence of bandwidth of different hosts, the following is my personal bandwidth aggregation method for your reference only.

1. Go to the console-> Devices

2. Find a host in the data center in the host list.

3. Go to Graph List on the right

4. Select None in the Select Graph Template column. Select the Host you just selected.

5. Enter the Title name displayed on the top of the image in the Title column. The width can be slightly larger.

6. Save the preceding configuration, for example, click Add on the right to Add the Configuration:

7. in the Host column above, select the previous Host name (XXX.149) from the drop-down list, select traffic_in (inbound bandwidth) in the Data Source column below, and select green in color, select Area for Graph Item Type (only Area is selected here, and this Item is not used later)

8. Add the last bandwidth value column to the image.

9. After adding the last value column, you can see the effect as follows:

10. continue adding the Average bandwidth (Average ),

11. After adding the Average, you can see the Average bandwidth value in the lower right corner. Continue to add

12. Add the maximum bandwidth value. Note that the small box below should be checked. The text and bandwidth values added later will be displayed in a line break.

13. After adding the maximum bandwidth

14. Add the incoming traffic of the second host, and add the Last (current value), Average (Average value), and Maximum (Maximum value) respectively. The steps are the same as those before.

15. After adding the inbound bandwidth of the two hosts, the outbound bandwidth is added. The procedure is the same as adding the watershed bandwidth.

16. Add the current outbound bandwidth value

17. Add the average outbound bandwidth

18. Add the maximum outbound bandwidth

19. Add the egress bandwidth of the two machines according to the previous steps, as shown in figure

20. Add inbound bandwidth summary. The Graph Item Type is LINE1, And the CDEF Function Column is different from the previous one.

21. When the current bandwidth is summarized, the CDEF Function Column is different from the previous one.

22. Add the average summary bandwidth value

23. Add the maximum bandwidth of the Summary.

24. The procedure is the same as adding a summary inbound bandwidth diagram. Then, add an outbound summary bandwidth diagram. The effect is as follows:

25. After adding the package, find the previous host (XXXA001) in Graph and you can see that the summary bandwidth information is displayed.

Because I wrote this blog for two days, the bandwidth information of the pictures is somewhat different.