CentOS uses NTFS-3G to load NTFS hard drive

CentOS uses NTFS-3G to load NTFS hard drive

When mounting NTFS Format hard disk CentOS will report the error unknown filesystem type 'ntfs ', then you need to use a third-party plug-in NTFS-3G to load ntfs Format hard disk. The NTFS-3G is an open source software that supports reading and writing NTFS format partitions in Linux, FreeBSD, Mac OS X, NetBSD, and Haiku operating systems. The main steps are as follows:

1. Install gcc and other compiling Environments

Yum-y install gcc automake autoconf libtool make

2. Download installation NTFS-3G

NTFS-3G official site is

wget http://tuxera.com/opensource/ntfs-3g_ntfsprogs-2013.1.13.tgztar –xvzf ntfs-3g_ntfsprogs-2013.1.13.tgzcd ntfs-3g_ntfsprogs-2013.1.13./configuremakemake install

3. Check the NTFS hard disk partition information. The red lines shown in the figure show my NTFS hard disk information.

Fdisk-l4. mount the partition

mkdir /mnt/ntfsmount -t ntfs-3g /dev/sdb1 /mnt/ntfs

After the partition is mounted, enter the/mnt/ntfs Directory, which is the partition of the mobile hard disk.

5. Detach a partition

umount /dev/sdb1

6. Mount the mobile hard disk automatically at startup and edit the/etc/fstab file.

Cp/etc/fstab/etc/fstabbak # Back up vi/etc/fstab # edit before changing, and add the following information at the end, mount Disk/dev/sdb1/mnt/ntfs ntfs-3g defaults 0 0: wq! # Save and exit

After the device is restarted, the mobile hard disk is automatically mounted.

7. When unmounting umount, the following message is displayed:

Umount:/mnt/upan: device is busy.

(In some cases useful info about processes that use

The device is found by lsof (8) or fuser (1 ))

Solution:

lsof -w /mnt/upan

Command pid user fd type device size/OFF NODE NAME

Bash 31761 root cwd DIR 8192 2316326 120526/mnt/upan/rekfan.com _

Using lsof-w/mnt/upan, we can see that there is a command window in the/mnt/upan/rekfan.com _ 120526 directory, close this window, or exit this mount directory, use umount to unmount the disk.