Centos7 Close Firewall Install iptables and configure, turn off SELinux

First, configure the firewall, open 80 port, 3306 port

CentOS 7.0 defaults to using firewall as the firewall, where the iptables firewall is changed.

1. Close firewall:

Systemctl Stop Firewalld.service #停止firewall

Systemctl Disable Firewalld.service #禁止firewall开机启动

2. Install iptables Firewall

Yum Install iptables-services #安装

After the OK is displayed, it indicates that the installation is successful, then proceed to the following

Vi/etc/sysconfig/iptables #编辑防火墙配置文件

# Firewall configuration written by System-config-firewall

# Manual Customization of this file are not recommended.

*filter

: INPUT ACCEPT [0:0]

: FORWARD ACCEPT [0:0]

: OUTPUT ACCEPT [0:0]

-A input-m state--state established,related-j ACCEPT

-A input-p icmp-j ACCEPT

-A input-i lo-j ACCEPT

-A input-m state--state new-m tcp-p TCP--dport 22-j ACCEPT

-A input-m state--state new-m tcp-p TCP--dport 80-j ACCEPT

-A input-m state--state new-m tcp-p TCP--dport 3306-j ACCEPT

-A input-j REJECT--reject-with icmp-host-prohibited

-A forward-j REJECT--reject-with icmp-host-prohibited

COMMIT

: wq! #保存退出

Systemctl Restart Iptables.service #最后重启防火墙使配置生效

Systemctl Enable Iptables.service #设置防火墙开机启动

Second, to close SELinux

Vi/etc/selinux/config

#SELINUX =enforcing #注释掉

#SELINUXTYPE =targeted #注释掉

Selinux=disabled #增加

: wq! #保存退出

Setenforce 0 #使配置立即生效

Centos7 Close Firewall Install iptables and configure, turn off SELinux