Check a key restore easy to achieve computer power-on restore

In our daily life, we sometimes need to set up computer power-on restore, hotels and internet cafes that is the most common. Power-on restore is mainly to protect our computer, so that the computer's data remain intact, no matter what you do to the computer, restart the computer, the computer is the same as before. How does this power-on restore work? We used the restore card before, and now we can use the check-and-click Restore to achieve it.

First of all, we went to check the key to restore the official website http://hy.gezila.com Download the latest version, installed to our computer above, after the installation is completed, restart the computer, you can use.

Second, create a backup. We run the grid one-click Restore, select Create Backup, and go to create backup main interface. We choose c, D, e three disk, note: power-on restore. As shown in the following figure (1)

(1) Create a backup

Click Create, 3 seconds, the backup is created OK. So our three plates are protected.

Third, set the power-on restore point. Select Advanced Features to enter the power-on restore option. We select the restore point we just created as the restore point for our power-on restore, as shown in figure (2) below.

(2) Set the power-on restore point

Click on "Open", the software will prompt you to "set the boot startup item successful!" So that no matter what you do to your computer, after restarting the computer, the computer is restored to the state of the backup you created.

Four, set the password. If we set up the power-on restore, we need to set the password to open the software, so if someone else uses our computer, also not afraid of him to cancel the power-on restore. Click to enter the program settings, we check "Enable password protection", this time will be pop-up password settings box, as shown in the following figure (3).

(3) Set the password

Set the password so no matter how others get our computer, we are not afraid of computer problems. If someone else enabled this software, or uninstall the software, will pop-up password box, do not enter the correct password, is not used.

In order to really realize the power-on restore, you also need to set the COMs password, so that even if the user with the PE system can not be destroyed.