China Telecom wireless broadband route sharing settings Guide

The following is a guide for China Telecom's wireless broadband route sharing settings. You should be familiar with the wireless broadband route sharing settings. The wireless cat provided in China Telecom's E8 package, the installer said that only two computers can be shared. The cat has no routing function, which is actually a lie. Its routing function is blocked, next I will introduce how to crack the wireless broadband route sharing settings:

1. Enter the vro to configure wireless broadband route sharing

First connect the network cable to a computer and set the TCP/IP attribute in the general attribute of the local connection,
◆ Set IP Address: 192.168.1.12
◆ Sub-off mask: 255.255.255.0
◆ Default Gateway: 192.168.1.1
◆ Preferred DNS server: 202.96.134.small can also be 192.168.1.1
◆ Open IE and enter 192.168.1.1 username and password admin.

Ii. Wireless Broadband route sharing settings

◆ Go to the local area network on the left of advanced settings, click DHCP, and enable the Local Area Network DHCP server.

◆ Learn the VPC and VCI data in the Quick Start Menu, which are 8 and 35 respectively. Then, click the extra network of the wide area network in advanced settings, and delete the bridging settings in Table 8/35. The deleted key appears in the bin on the right of the pencil mark ). Do not close this page.

◆ The WEB address configured for routing is blocked by China Telecom.) open the new IE page and enter 192.168.1.1/unnumppp. cgi? NtwkPrtcl = 0. Select "automatically retrieve Wan address" and "enable Network Address Transfer for NAT. Then, click Next. A message is displayed, indicating that the PPP user account and password are entered. Enter the account and password provided by China Telecom and select "always online.

◆ Click Next. In the displayed table box, click Finish. If you are not prompted to save or restart the vro, click the system management menu on the previous page to manually restart the vro. In this way, when you enter the ZTE 531B router again in two minutes, you will find that the 8/35 Bride (bridging) vpi/vci in the Wide Area Network has become the 8/35PPP0E virtual dialing item.

◆ Wireless broadband route sharing settings: Set the wireless Nic attribute of several other computers in the home to automatically obtain the IP address. If you still need to dial up, prove that when you restart the cat it did not save your settings, the second case is your Nic settings, I also met, D-LINK G520 requires me to first install the driver, then install the network card, it is also required to avoid WINDOWS configuration. In this way, only one wireless device is used for both of my two devices. As a result, I select WINDOWS as the NIC, and all three devices can be used.

◆ Because I have a wired network and two wireless networks, the IP address set for one of my wired networks has not changed, but is still specified. The IP address on the top has not been changed, but through the above process, from the dial-up of the network card on each computer, set a limit of more than two in the cat, it will become the direct dialing of the cat, the rest as long as the IP address is automatically obtained, you have ten or eight servers.