Cisco emulator configuration VLAN across switches

Network topology diagram Building

As shown in the figure, PC0 is connected to the F0/1 interface of Switch0, PC1 ——-SWITCH0/2,PC2--SWITCH1/1
PC3--SWITCH1/2, and then the switch uses a crossover line to connect their third interface

Note: Direct connection is required between the host and the switch, and the host IP address needs to be configured with a crossover line between the switches

Mouse click on the host, will pop up such a box, you can see the first is the IP configuration, point in the configuration can be


Each of the four hosts is configured with a configuration switch that divides the VLAN

Click the switch to eject this window and start dividing the VLAN

Divide the port into the appropriate VLAN
Configure Trunk

The same on the second switch also follow the corresponding steps to configure the test

Now that the configuration is basically over, ping it and try it:

Success. Make a little progress every day