Color droplet graphics for synthetic power flow in Photoshop

A single water droplet figure has no characteristics, but with a group of such graphics, replacement of different colors, partial retention of some transparency effect, and then superimposed by a certain way, the effect is very good.

Final effect

1. Create Canvas and dye black. Select the Ellipse tool (U) and hold down the SHIFT key to draw a brightly colored positive circle. Drag a guide to align with the center, and then Ctrl+t, holding down the SHIFT key to rotate the top circle 45 degrees. Select the path of the circle with the direct selection tool (A), and then use the pen (P) tool to add an anchor point to the circle as shown in the diagram, with the Pen tool and the direct selection tool to adjust the circle to a droplet shape.

2, add a mask to the above graphics. The gradient color is black to white, and the gradient is linear. Press the G key to drag on the mask while holding down the SHIFT key to fill the gradient, adjust the gradient position, so that the tip of the water droplets is covered by black (pictured below).

3, copy the above graphics (CTRL+J) and make the appropriate scaling, and flip horizontally. Then slightly change the color (slightly darker or lighter). Move the graphic to the position shown in the figure. At this point you may need to change the color of the black and white gradient in the mask, just follow the steps in step 2 and adjust it slightly.

4, repeat the above steps and create a group of such graphics.

5, select all the graphics just drawn, ctrl+g grouped and named. Then add the mask, set the gradient slider from black to white, and select the gradient to be a radial gradient. Press the G key, and then press the SHIFT key to drag the mouse from the middle to the outside.

6, the whole group of copies of the above graphics, change the color of the group's graphics. Enlarge or shrink the new group and rotate it by 180 degrees. Or you can add a radial gradient to the new group as per step 4.

7, you can also do a number of different modifications to the group above, for example, to change the blending mode of a group to "lighten", or to change the transparency of a layer to 50%. Finally add the decorative text, complete the final effect.

Note : More attention to Photoshop tutorial section, triple PS tutorial Group: 181754111 welcome you to join

Category:

• PS Composite Picture Tutorial