Common hard drive self-test failure analysis

General hard Drive Self-Test failed, if not the primary boot module or the DOS boot module is compromised (such as virus infection), then other symptoms are basically caused by external hardware. Software can be used to kill antivirus software boot zone virus, or with Norton, Debug, such as repair (more trouble), hardware in accordance with the post after the information prompted to analyze.

1 post completion prompts the following error message: Hddcontrollerfailurepressf1toresume

When the above information, you should focus on the hard disk-related power cord, data cable interface is loose, bad contact, signal wire connection, and so on, and then check the hard disk jumper is set wrong. Last year Qurro save their own love machine, because bought a bad hard drive line, resulting in hard disk can not be lifted (the motherboard with the good hard drive line to connect the CD-ROM drive), the result of a nasty cold sweat.

If this is not the case, then try to change the hard disk, it is possible that the hard disk itself is a problem.

2 Boot Memory self-test displays the following information: Fddcontrellerfanilurehddcontrellerfanilure

Presstoresume

If the above information is usually connected to the soft, hard disk I/O part of the contact is bad or damaged, this is more trouble, light can also be repaired, serious bad will have to change the son.

3 Boot Display the following information: drivenotredayerrorinsertbootdisketteinapress

Anykeywhenready ...

If these errors occur, many of the "C:" type is not set or because the CMOS power supply is insufficient, resulting in CMOS information loss.

The above is just some common hard drive failure reasons, if it is the first "1" "3" category, you can manually exclude, if "2" category of problems, their own bad hands, it is best to the manufacturers or to ask professional to repair it.