The8Day: Switch configuration command
Lab01: Communication between computers
Lab Objectives
Communication between computers
Lab Environment
Install a Cisco simulator computer
650) This. width = 650; "Title =" \ "image001.png \" "alt =" \ "wkiol1pnvbnyp1yyaaereq9nfoo145.jpg \" "src =" % 5c "/>
Lab procedure
1. Configure the IP addresses and default gateways of the four computers respectively.
1. pC1: 192.168.1.1 PC2: 192.168.1.2 Gateway: 192.168.1.254
PC3: 192.168.2.1 pc4: 192.168.2.2 Gateway: 192.168.2.254
Double-click pc0 computer | enter IP Address Configuration and Network Management Configuration
650) This. width = 650; "Title =" \ "image004.jpg \" "alt =" \ "wkiom1pnu0hj8y5paadlo81jpbm455.jpg \" "src =" % 5c "/>
2. Configure the PC2, PC3, and pc4 computers.
2. Enter the vswitch for related configuration
1. Configure swit1 to go to vlan1 to configure the IP address
650) This. width = 650; "Title =" \ "image006.jpg \" "alt =" \ "wKiom1PnVFPC6OV-AAC8U7BdFx8184.jpg \" "src =" % 5c "/>
2. Configure switch1 Default Gateway 192.168.1.100
650) This. width = 650; "Title =" \ "image008.jpg \" "alt =" \ "wKiom1PnVGyDuFhjAACGT-1C-LI677.jpg \" "src =" % 5c "/>
3. Configure switch2 and go to vlan1 to configure the IP address.
4. Configure switch1 Default Gateway 192.168.1.200
650) This. width = 650; "Title =" \ "image010.jpg \" "alt =" \ "wKioL1PnVZ-jkxCDAADlnV02Otw504.jpg \" "src =" % 5c "/>
3. Configure router interfaces F/0 and 1 Gateway
Result Verification
1.Result of pC1 fight PC3
2.Result of Pc2 combination with pc4
Problem and Experience Summary
1.Configure vro interface IP Address
Global Configuration Mode Interface fastethernet 0/0
IP address192.168.1.254 255.255.255.0
No Shutdown
2. Configure the default gateway of the vswitch
Global configuration mode IP default-Gateway 192.168.1.100
Note: The purpose of vswitch gateway configuration is to achieve remote management of vswitches for hosts in different network segments.