Comparison and Evaluation of vro transparent bridge and Bridge Mode

Today, I will take the flying fish star router as an example to compare the configuration of the transparent bridge and bridge modes. Let's take a look!
I. configuration in bridging mode (1) the network is 192.168.1.0/24, and the bridging mode is enabled for the external port of VE1260. After the bridging mode is enabled, the outer port of the flying fish star router is automatically disabled without configuration, direct the gateway address to the IP address of the internal network port of the Upper-layer device.

(2) configure the Intranet port of VE1260, and configure an IP address in the same network segment as the computer but not used. Configure 192.168.1.2 in the same network segment.
(3) restart the flying fish star router.
Ii. Transparent bridge mode configuration (1) the network is 192.168.1.0/24. Configure the Internet port of VE1260 and allocate a static IP address in the same network segment as the computer, the gateway points to the IP address 192.168.1.1 of the Intranet port of the Upper-layer router.
(2) configure the Intranet port of the VE1260, and configure an IP address or the same IP address in the same CIDR block as the Internet port, and configure 192.168.1.3 in the same CIDR block.
 
(3) Restart all the Intranet devices, including the switches at the center layer below. At this point, the Intranet computer can normally access the Internet without modifying the original IP settings, and can perform online behavior management on the Intranet computer on the VE1260, which is very fast. This article is from