Comparison of vro installation methods

Many people ask this question. How can I install a router? According to the instructions, it is easy to set up. I will give a detailed description of some unclear points. First understand the IP address and PC settings.

How can I install the GGJJ router?

How to install a vro:
Simple. there are instructions. connect the network cable to the IN port of the router first (generally a separate one, which is separate from other ports ), connect the network cable on the computer to the router's OUT port (usually Port 1 and 2), plug in the router power, open the computer, and perform the following steps.

1. Find the router IP address in the manual. If the IP address is not changed, the IP addresses are 192.168.0.1, 192.168.18.1, and 10.0.0.1. The following uses 192.168.18.1 as an example.

2. Find the vro username and password in the manual. Most of the user names or passwords are admin and root. Here, the username admin and password admin are used as examples.

3. Open IE or another browser and enter http: // 192.168.18.1/, that is, the router IP address. The login verification window is displayed.

4. Enter the User Name admin and password admin, that is, the user name and password mentioned above to enter the management interface.

5. If no IP address is found, the IP address is changed. It doesn't matter. There is a very small RESET button on the vro. Press it to restore the factory settings.

6. Welcome, no matter what it is, next step

7. The system prompts you to select the Internet type. You only need to select ADSL virtual dial PPPoE. If you have special requirements, follow the wizard prompts. The following uses ADSL virtual dialing PPPoE as an example.

8. Enter the internet password and password. The username and password used to purchase the bandwidth. Most routers do not support dialing.

9. The settings are complete. Save. Then, click the "Connect" button to work properly.

How to install a vro, PC settings:

1. How to install a vro, Windows 95/98/ME
After entering the operating system, click "start"-& gt; "Settings"-& gt; "Control Panel" on the taskbar and double-click the "network" icon, select "Internet Protocol (TCP/IP)" on the "Configure" page ", click" properties ", select" specify IP Address "on the next page, and enter the IP address 192.168.1.2, subnet Mask 255.255.0; Add the gateway 192.168.1.1 on the "Gateway" page, and enter the DNS server later. click "OK" on the page and "OK" on the "network" page ". restart the PC as prompted.

2. How to install a vro, Windows 2000/XP
Taskbar "start"-& gt; "Settings"-& gt; "Control Panel", double-click "network and dial-up connections ", click "Local Connection" corresponding to the NIC connecting to the Broadband Router, right-click and select "properties", and select "Internet Protocol (TCP/IP)" on the "General" page displayed )", view its "properties", select "Use the following IP Address" in the pop-up page, and fill in the IP address 192.168.1.2; subnet mask 255.255.0, default gateway 192.168.1.1. enter the DNS server later. click "OK" on the page and "OK" on the "network" page ". wait until the system configuration is complete.