Computer boot local connection to start a slow solution

This occurs generally because of three causes:

One, the computer starts the process service too many or the program software too many causes.

Second, the operating system of too many garbage files or disk fragments too much caused.

Third, it is also important that there is a problem with the local connection settings.

If we set the local connection settings to automatically get IP, in this case, after starting the computer, the computer will automatically start the DHCP process service, so as to obtain the IP address of the network connection, in the start of this service and access to IP process, we will find that the system will produce 30-40s suspended animation state, That's why we don't have a response to running a computer some time ago after we started the computer. So in order to solve this problem, we recommend that you set up a local connection IP address.

Here are some other reasons for the slow start of the local connection, small series for the specific analysis:

1, first we have to ensure that the computer does not contain viruses, Trojans. Because the computer in the Trojan may also lead to such a phenomenon, we suggest that every once in a while to conduct a comprehensive scan, if no virus or trojan, we look at the following content.

2, the use of computer optimization software to the computer some of the startup program to optimize, about the settings for the startup item,

Computer knowledge

3. After optimizing the Startup items, we start to clean up some garbage files or programs of the computer system, and reduce the speed of the software memory. Concrete operation we can use 360 security guards, optimization master and other software to deal with, small series here is not introduced in detail.

4, the above to introduce you to the 3rd, about the IP settings, in this small set for everyone to say, first of all, we must obtain the IP address of the Internet now, can set fixed IP, obtain the method of IP address as follows:

Turn on the start >> run in the lower left corner of your computer, and then enter the cmd command in the pop-up window, as shown in the picture:

Then in the pop-up interface, we enter the "ipconfig" command and return, in the display of the IP address of the interface, we can see their own IP address. As shown in the figure:

So we can get the IP address of this computer, and the IP address of the router, then we write down these two IP addresses into the local connection to set up.

Open the network place on your desktop, and then click to view the local area connection, then click the right mouse button on the local connection, and then select the property option, as shown in the figure:

We then select "Interent option" in the pop-up interface and click on the Properties button as shown in the picture:

After that, in the pop-up interface, we set the specific IP address, OK.

This allows us to set the IP address, in the future boot, we will omit a step, to start the local connection will be helpful.