Computer Wireless internet Tip "Wireless network is not found in the area" what to do?

Case study One:

The laptop is fine, and suddenly you can't use the wireless network, which prompts you to "not find a wireless network in the zone." There are three main questions:

One, event log is disabled by 360, enabled

The old version of 360 in "one-click Optimization", by default, "Event Log (System Log service)" to the shutdown. The following is a detailed solution:

1, open "Event Log (System Log service)": 360 software Open, and then enter: click "full-featured"---into the "system service Status" or "power-on acceleration"---Select "Service"---Select "System critical Services"----find "Event log" (System Log service) ”。 If the current state is started, skip this step, or if the current state is disabled, click Resume Startup, and the current status will be turned back to started.

2, open "Wireless Zero Configuration (Wireless Configuration Service)": The same step, find "Wireless Zero Configuration (Wireless Configuration Service)": If "Current state" is "started", skip this step; The current status is disabled, click "Resume Startup", then "current status" is turned back to "started".

Note: If 360 is not installed, enter the Services.msc in the start-run and find the above two services and turn it on.

3, double-click the computer in the lower right corner of the wireless connection, and then click "Properties", click on the above "Wireless network Configuration" button, and then "Use Windows to configure my wireless connection settings" before clicking "OK", again open "View available wireless connection" to see if ok!

4, restart the computer.

Second, the wireless card hardware switch is turned off

Each laptop usually has a wireless card hardware switch, some on the front side, some on the side of the power switch (Touch key). Turn the hardware switch back on.

Third, the wireless network card driver has the problem: it is recommended to uninstall the wireless network card driver, and then reload Drive. Through Baidu "Drive Wizard", after installation can automatically retrieve your system drive.

XP Uninstall Wireless Adapter driver path is as follows: My Computer---(right)-----Properties---Hardware----Device Manager-----Network adapter

Case Study II:

Just installed wireless network driver (notebook from Vista reload to XP), wireless network icon also see, but not even on the network, the hint "wireless network in the area can not find", how to do?

Then you need to check if it's a book. Disable the wireless adapter, and check the following 2 items in turn:

1 in your wireless connection, right-click to enable.

2 you find in the notebook, with the combination of function keys to open the wireless network card, is the lower left-hand corner of the FN key and f1~f12 in the wireless signal in the key at the same time press it! You can't find it. Look at the notebook instructions, there will be a combination of function key prompts.

There are two possible scenarios where a wireless network does exist in the zone and the wireless network is normal:

1 driver problem with wireless network adapter uninstall Reinstall

2 Wireless card itself problem I remember that HP has a laptop is not a wireless network card, for some wireless networks do not search (but for some but also can!!! This I am also very depressed) you can use the USB interface of the independent wireless network card to try.

XP operating system under the access connections and the system from the wireless features can not be used at the same time, we recommend that you choose one.

How to: If you use only a wireless connection with Windows, you need to turn on the network connection, right-click the Wireless connection icon, select Properties, and then select the Wireless network configuration option (if you do not have this option, you need to enter "Services.msc" in the Run bar) Then find the wireless Zero configuration to see if it is enabled and if not, enable it

Select "Configure my wireless network with Windows" to stop using the AC software (accessconnection) and if you use the AC software, cancel the previous option, then create a new profile, save your settings, and connect directly.