Configuring the Cisco Wireless Fat AP 1130

1. Configure the IP provided to you by the service provider for the Ethernet interface of the AP.

Ap#conf T

AP (config) #int F0

AP (config-if) #ip add 10.48.2.154 255.255.0.0

AP (config-if) #no Shu

AP (config-if) #exit

AP (config) #ip Default-gateway 10.48.0.1

2, configure the BVI interface:

AP (config) #int BVI 1

AP (config-if) #ip add 10.48.2.155 255.255.0.0

AP (config-if) #no Shu

The VBI interface configures the IP address and can be configured via a Web page. The Web page access address is the address of the BVI interface.

3. Configure DHCP for a shared wireless network if there is a DHCP server here that can not be set. In some cases, DHCP relay can be configured.

AP (config) #ip DHCP pool AA

AP (dhcp-config) #network 10.48.0.0 255.255.0.0

AP (dhcp-config) #default-router 10.48.0.1

AP (dhcp-config) #dns-server 202.102.224.68

AP (Dhcp-config) #exit

Exclude IP addresses that are assigned in DHCP

The AP (config) #ip DHCP excluded-address 10.48.0.1

The AP (config) #ip DHCP excluded-address 10.48.2.154

The AP (config) #ip DHCP excluded-address 10.48.2.155

AP (config) #service DHCP

The commands for configuring DHCP relay are as follows (go to the specific ports and configure them):

AP (config-if) #ip helper-address 192.168.0.1

4. Turn on wireless and set SSID

AP (config) #interface dot11radio 0//Enter the broadcast 0 interface, the General raido0 is 54m,raido1 for 11M

AP (config-if) #encryption mode ciphers TKIP//Set encryption mode to TKIP

AP (config-if) #ssid Cisco-ap//Set up and enable SSID,CISCO-AP SSID name

(The following command may not be able to use the TAB key to auto-complete, do not worry, direct input is OK)

AP (CONFIG-IF-SSID) #authentication Open//enable authentication

AP (CONFIG-IF-SSID) #authentication key-management WPA//encryption algorithm using WPA

AP (CONFIG-IF-SSID) #guest-mode//Guest mode, this = turn on SSID broadcast function in normal wireless router

AP (config-if-ssid) #wpa-PSK ASCII Cisco//Set the password to ASCII character, password for Cisco, password in addition to ASCII characters can also be used in hexadecimal digits, but hexadecimal numbers are too cumbersome, Using ASCII characters is more intuitive and easy to remember.

5, configure the Wireless interface: Dot11radio 1, this interface can not be configured.

AP (config) #int Dot11radio 1

AP (config-if) #ssid Cisco-ap//Set and enable Ssid,spider for SSID name

AP (CONFIG-IF) # encryption mode ciphers TKIP

AP (config-if) #no Shu

Ap#write

Building configuration ...

[OK]

6. View the users connected to the AP

Ap#show dot11 Associations

You can use the IP HTTP Server command in global configuration mode to turn on the Web Interface Configuration service and configure more commands such as wireless network encryption in the Web interface.

This article from the "Erick" blog, declined to reprint!

Configuring the Cisco Wireless Fat AP 1130