Configuring the Remote network management Cisco routing switch

In actual work our routing and switches are always placed in the room to facilitate our work we need to configure the routing and switches so that we can configure the routers and switches in the office or at home.

This is a simple network topology diagram where a computer-connected route configures the switch across network segments

First we determine the PC ip:192.168.1.1 255.255.255.0 gateway 192.168.1.254

Routing gigabit0/0ip:192.168.1.254 255.255.255.0

Command r1>enteral to turn on privileged mode

R1#config Terminal into global mode

R1 (config) #interface gigabitethernet 0/0 into Gigabit Port 0/0

R1 (config-if) #ip address 192.168.1.254 255.255.255.0 0/0 Port IP Settings

R1 (config-if) #no shutdown activation port configuration

R1 (config-if) #exit返回上层对下一个端口进行配置

Routing gigabit0/1ip:10.0.0.254 255.255.255.0

R1 (config) #interface gigabitethernet 0/1 into Gigabit Port 0/1

R1 (config-if) #ip address 10.0.0.254 255.255.255.0 Configure IP

R1 (config-if) #no shutdown activation port

Switch configuration virtual vlan1ip:10.0.0.1 255.255.255.0

Switch configuration Ideas--Privileged password settings--vlan1 ip--configuration gateway--Remote login password settings

Switch>enable Entering privileged mode

Switch#config Terminal into global mode

Switch (config) #hostname WR1 to change the name of the device for easy configuration later

WR1 (config) #enable password 123 configuration password 123

WR1 (config) #interface vlan 1 into vlan1 configuration

WR1 (config-if) #ip address 10.0.0.1 255.255.255.0

WR1 (config-if) #no Shotdown activation port

WR1 (config) #end return to privileged mode

Wr1#write Save

Wr1#config Terminal into global mode

WR1 (config) #ip default-gateway 10.0.1.254 Configuration Gateway

WR1 (config) #line vty 04 Configure the remote port 0-4 host

WR1 (config-line) #password 456 Set Password 456

Wr1#write Saving a configuration file

Finally verify the configuration

---------validation failed

[Connection to 10.0.1.1 closed by foreign host]

Continue tomorrow.

Configuring the Remote network management Cisco routing switch