Connect to Linux using SecureCRT

1, after logging into the Linux system, enter ifconfig to view network card information

2. Set up VMware Virtual Machine connection mode to host only

3. View VMware as host-only virtual network card IP address (VMware network Adapter VMnet1)

4. Check the IP address of the current Linux system NIC and enter Ifconfig, as

5. Use Ifconfig to temporarily add a 192.168.67.2 segment IP address to the eth0 NIC, such as

Ifconfig eth0 192.168.67.2

6. Create a connection using the SECURECRT tool

7. Connect the Linux system using SECURECRT

8, after the connection, enter the LS command to see if the connection is successful

9, ok! If you can see the picture above, the explanation is done!

Connect to Linux using SecureCRT