Coolpad Y1 Brush Machine method

From http://blog.zhangciba.com

Description, this method can be brush does not normally enter the system of mobile phones, is commonly known as the Brick machine, you can also brush the normal phone, you deserve to have.

The steps of the brush machine are as follows:

Getting ready to install cool phone driver

Click I download the cool driver, after downloading, install it.

Download the corresponding Brush pack for the Y1 phone

This article describes the cool current has a brush machine package, you can go to download point I check the Brush pack post, please download the official brush package, so that you can use Coolpad Download Assistant to brush the machine. After the download is complete, unzip the package and you can see a suffix called. cpb file, this is the brush machine package.

Download the cool mobile phone brush machine tool

Brush machine tool name is called Coolpad Download Assistant (cool send download assistant), download link address is point I download Coolpad Download Assistant
After the download can be installed, the process is the next step, after installation, the desktop will appear a blue upload logo icon, is the software shortcut.

Start the Brush machine

When the driver is installed, after the CPB brush pack download, and then more than 50% power, you can use the Coolpad Download Assistant Brush machine.

Please be aware that the battery must be more than 50%, or the failure of the brush machine may lead to damage to the chip.
Be sure to download the official line brush package, otherwise you cannot use this method to brush the machine if you do not include the. cpb file.

Mobile Phone Connection Computer

The way that cool-Y1 mobile phones Enter fastboot is like this. When the phone is completely shut down, the battery can be unloaded, and then installed, please be careful not to plug in the data cable. Then press the volume up key, keep pressing, and then use the data cable to connect the phone to the computer, the following interface and then release.

After this interface, click the Volume Plus, enter the following interface to indicate that you can brush the machine.

Please ensure that the phone is fully charged, in addition to ensure that the mobile phone connection is stable, in order to avoid the process of the brush-off caused by the failure of the brush machine.
In order to verify that the driver installation was successful, the device in the following image should be visible in Device Manager under Windows System. The way to open the setting manager is to right-click on the computer icon and the Device Manager will be able to enter it.

If it does not appear, click on the computer name, right button, scan hardware changes can be. If it doesn't work, you can reinstall the driver and then reconnect your phone to the computer fastboot. (Repeat again, turn off the phone completely, press and hold the volume plus key, plug in the data cable to connect the computer, picture as shown above)

Unzip the CPB line Brush pack

The General Brush machine package is in the form of a compressed package, after the download is complete, unzip, get a. cpb suffix file.
If you do not have a. cpb file, you are not downloading the official line Brush Pack, please note that you must download the official line Brush pack.

Brush machine using the Brush machine tool

First open the Coolpad Download Assistant software, the interface is as follows:

Make sure the phone is connected , and the connection method reference before the steps

Next select the Brush package file:

Then start the Brush package verification:

After the verification is complete, the machine starts to brush:

Wait about 10 minutes, brush the machine complete,:

After the brush machine

After starting the phone will be stuck in China Telecom's welcome interface, this time, you can unplug the battery, and then restart, you can enter the system.
OK, brush the success of the machine, try to enjoy it, after the boot, you can use other tools to brush the machine.

Coolpad Y1 Brush Machine method