Describes Henan Netcom router settings

At present, there are many users who use routers. It does not matter if many people do not know how to set up Henan Netcom routers. After reading this article, you will certainly have a lot of GAINS. I hope this article will teach you more. Henan Netcom router settings:

I. Hardware connection:

1. Connect the RJ45 line of the ADSL cat to the WAN port of the router, and connect the computer to 1-4 ports or cascade Switches of the router.

2. Power the vro to ensure that the hardware works properly. The RUN light is shining normally.

2. Set the Internet access machine:

1. Set the IP address of the network card to automatically obtain or set to a fixed IP address.

2. You can also set all hosts on the Internet to automatically obtain IP addresses.

3. Internet access settings:

1. The default vro address is 192.168.0.1, And the username and password are admin.

2. Enter http: // 192.168.0.1 in the address bar of the Local Computer IE browser, and press enter to enter the user name and password admin. Enter the vro configuration page.

3. On the left side of the vro configuration page, click WAN port settings. There are four options in the Internet access mode. The default method is Henan Netcom DHCP, select based on your network conditions:

◆ Henan Netcom DHCP +: select this option if the access line is in the DHCP + mode of Henan Netcom. Enter the account and password that Netcom provides to you.

◆ Dynamic Address automatically obtained from the DHCP server): the access line is an automatically allocated address. You do not need to select this setting for human and other operations.

◆ Manual Address Allocation for static addresses): the access line is the selection of a fixed IP address assigned by the carrier. You can enter the IP address assigned by the Operation and the gateway. Such as optical fiber lines.

◆ PPPOE includes Netcom PPPOE users): If the access line uses this Protocol to access the Internet, select this option and enter the account and password provided by the carrier. For Henan Netcom users, refer to Henan Netcom PPPoE check box. For example, the upgraded ADSL line for Henan Netcom users, China Telecom and China tietong. Note: currently, Henan Netcom has two lines. One is DHCP + and the other is pppoe. You can perform debugging based on your actual situation.

4. You can access the Internet after setting the corresponding line.

5. If you forget the router address or user name and password, press and hold the "RESET" key for more than five seconds to restore the factory settings.