Detailed configuration process of dynamic route protocol RIP (1)
This blog post is from Bkjia blog bvbvbvbv07. If you have any questions, go to the blog page for an interactive discussion!
Blog: http://zhang2015.blog.51cto.com/9735109/1618123
First, set up the IP address of the topology planning and find out what needs to be configured and the lab requirements ......
Configuration cycle: the first step is to configure loopback to simulate the Internet and the IP addresses of each port
Then, configure the relevant properties of the RIP, and view the route table after the configuration is complete. You can also view the routing protocol information. Finally, ping Command Experiment
R1 router configuration
Configure loopback and port IP address information
The following is the process and result of configuring RIP.
Note: The following route table information can be queried only after RIP is configured.