Diagram of peer-to-peer wireless network connection settings

Peer-to-Peer wireless network connection settings are a way to achieve wireless Internet sharing. How can this approach be achieved? This article will show you how to configure peer-to-peer wireless network connections. We hope that you can learn this knowledge through the graphic introduction in this article.

Note that the user who uses the notebook should first turn on the WIFI switch. After the device is turned on, the system prompts you to find the wireless network card and install the driver as prompted. Restart the computer and configure the computer connected to the Internet. After entering the control panel, follow these steps.

Step 1: Enable "network connection \ wireless network connection \ properties", double-click the TCP/IP protocol, and set the IP address to 192.168.0.1 in the window shown in; set the subnet mask to 255.255.255.0.

Set IP

Step 2: switch to the "wireless network configuration" tab, select "configure my wireless network settings in Windows", and switch to the "advanced" tab, in the "Network to be accessed" window, click "computer to computer only ".

Select computer only to computer

Step 3: return to the "Wireless Network Connection Properties" dialog box and click the "add" button. In the displayed dialog box, in the "Network Name (SSID)" dialog box) "box, enter the SSID value, select" open network verification ", select" WEB "for" Data Encryption ", remove the" automatically provide this key for me "check box, and enter the corresponding network key, click OK to exit.

Wireless Network connection settings

Step 4: Find the network connection between the local computer and the Internet, and switch to the "advanced" tab in the Properties dialog box, as shown in. Then, select "allow other network users to connect to the computer through the Internet Connection". For the other option, you can decide whether to choose based on the actual situation.

Advanced attribute settings

Step 5 of peer-to-peer wireless network connection settings: Set the IP address of another computer to a value other than the host, enter "192.168.0.1" in the "Default Gateway" column. If everything is normal, the wireless network connection will immediately change from disconnected to normal, and the network address will be obtained at the same time. At this time, the wireless connection signals of the two computers will also be established.