The application topology where TL-WR700N works in Bridge mode is as follows:
TL-WR700N wireless Bridge mode application topology
1
Confirm the master router parameters
Log on to the management interface of the wireless router (that is, the main router) to be bridging, and confirm
SSID,
Channel,
Wireless passwordThe following table is used as an example:
Note: The parameters here are for reference only. The actual parameters are used in the real environment.
2
,
Set wireless network card
Before setting a vro, you must set the wireless network card of the operating computer to automatically obtain the IP address. If you do not know how to set it, refer:
Pull the pattern switch of the TL-WR700N
AP
Mode, As shown in the following figure:
The default SSID of the vro is:
TP-LINK_XXXXXX(The last six digits of the MAC address), select the operating system of the computer on the following icon, and set the wireless signal for the computer to connect to the Mini router according to the instructions in the document.
1
, Enter the management address
Open the browser on the desktop, clear the address bar, and enter
Tplogin.cn, And the login box will pop up after you press Enter.
2
, Logon Management Interface
If this is the first login, you need to set the management password of the router. In
Set password
In
Confirm password
And click
OK. If you have set a password, enter the password to go to the management page.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select work mode
Select
Bridge
: Bridging mode, Click
Next Step.
3
Modify wireless parameters and scan signals
Modify
Of this device
SSID(Wireless Signal name), fixed
Channel, Click
Scan.
4
Select the main router signal
Find the SSID of the primary router on the scan page, and click
Connection.
Note:: If the signal of the primary router is not scanned, make sure that the wireless feature is enabled on the primary router and try to reduce the distance between the primary router and the Mini router.
5
Enter the wireless password
In
KeyEnter the wireless password of the master router and click
Next Step.
6
, Settings
Mini
Vro wireless password
In
PSKPassword Set wireless password, clickNext Step.
Note:The SSID and wireless password of the Mini router can be different from that of the primary router. To achieve roaming, you must be the same as the primary router.
7
, Set, restart the router
Click
Restart, Click in the pop-up dialog box
OK.
The name of the wireless signal (Wirless_ B) after the computer connects to the TL-WR700N ). Log on to the management page and click
Running status, Observe
Wireless status
>
Bridging status, Display
SuccessfulThe Bridge mode is successfully set.