Login is to turn on remote login password verification, login local not only requires a password, but also requires the user name
If you set both login and login Local,login local valid
(config-line) #line vty 0 4; Set the number of remote connections, allowing 0 to 41 total five connections
(config-line) #password 123; Set Telnet (that is, Telnet) password to 123
(Config-line) #login; Turn on remote login password verification
Login means to open remote login (telnet) password authentication, if not login, remote login is directly logged in, even if the remote login password has been set, does not require password authentication
(config-line) #login local; When setting up Telnet, enter the user name and then enter the password before you can log in. and login just asks for a password.
(config-line) #line vty 0 4
(config) #username Hello password 123; Set user name Hello, password 123
Note: In general, the Cisco device default is login, that is, you configured the password and then remote login switch is to certify that you entered and now the password is not match, if you enter password XXX after adding a no login The remote login switch will not be verified, just enter a password can be entered, generally do not consider the situation of login
Differences between login and login Local in Cisco commands