Disassembly of the CPU heatsink and decomposition of installation steps

CPU heatsink is used to heat the CPU, the radiator on the stable operation of the CPU plays a decisive role, the Assembly of a computer when a good radiator is very important, how to disassemble and install the CPU heatsink?

　　Removal and installation of CPU Heatsink

　　Disassembly steps:

First step: First find the heatsink 4 corner of the buckle, the knob in the counterclockwise direction of rotation 90 degrees.

Step two: Lift the clip up. Once the 4 fasteners are lifted, lift the heatsink up to remove it.

　　Installation steps:

First step: First check the heatsink on the 4 buckle knob is not kept in the figure shown in the position, if not, please turn them clockwise gently to not turn until.

The second step: Find the motherboard on the CPU around the 4 buckle hole position, the heat sink 4 buckle plug for the quasi-4 holes inserted.

The third step: to ensure that the lower end of the 4 buckle pin has been inserted into the motherboard's fastener jack (can no longer be inserted), and then press down on the knob, until you hear "click" a sound, it means that the buckle has been in place. Once the 4 clips are pressed down into place, this step is complete.

Fourth step: On the back of the motherboard to check the Heatsink 4 buckle pins are in place, must be 4 pins to present the picture in this state (the middle of the latch is fully highlighted), only to indicate that it is in place.