Disk Partition deletion and restoration process by mistake

 

 

January 21

1. Brief description of the status before the problem: 40 GB disk, divided into three areas:
==================================
Primary partition 1 FAT32 4G
Primary partition 2 FAT32 1g
Expansion zone 3 35g
------ Logical partition 3.1 FAT32 35g
==================================
The error message returned when the partition 3.1 is deleted by mistake, with 33 GB of files.

2., WINXP management tool, accidental deletion of logical partitions xx

3. If pm8 is used for restoration, the logical partition cannot be found. If undelete is used in Expansion Area 3, the system prompts that the partition cannot be restored.

4. Use easyrecovery recovery, select advanced recovery, and select FAT32 for Full scan. The logical partition and all files can be found within 30 minutes, but cannot be restored in the source partition, only other disks can be exported. Give up. In addition, a total of GB deleted files are scanned. The filter function must be used to retain normal files.

5. Run the command in diskman or dos. The interface is unfriendly and the menu commands are vague. Start to select "Activate/restore partition". After running the command, it is found to be an active primary boot area. Then, find the "Restore Partition Table" menu and prompt you to back up the file, so you are very worried about Misoperation and give up. In addition, diskman is used to back up a partition table with an error and save it with sys and USB flash drives.

6. Use "easy my Partition Table doctor". The interface is friendly. After scanning, all partitions are found. Select "Restore all partitions" (Note: Select "all partitions" instead of "Lost partitions"). Save and rely on, you must use the registration code to Solve the Problem online. OK.

7. Restart, logical partition recovery, and WINXP disk scan. It seems that there is no problem. The previously incomplete BT check is also normal.

Finally, I would like to thank the author of table store.