DLink Router configuration internet dynamic IP configuration Internet (fiber-optic household)

Fibre Line connections:

For the first time installation, two cables are recommended. From the Cat LAN port to connect a network cable to the router intrnet port, and then use another network cable from the router LAN port to connect to the computer. If only a line, you can connect the computer and the router, configure the router and then unplug, reconnect to the ADSL modem and router Internet port, or notebook, mobile phones and other devices wirelessly connected to the router for configuration.

If the diagram is finished, see if the LED is normal and light, if not, please refer to: The light is not bright, how to handle?

Login Router Management interface:

Open the browser in the Address bar to enter http://192.168.0.1, as shown in the figure:

If not landing router interface, please refer to: Can not enter the management interface, how to deal with >>http://www.111cn.net/router/dlink/113703.htm

To configure the router:

First, dir-605l, dir-619l system router

Step one: In the "Network Connection Settings" selection: Dynamic IP, in the wireless connection settings to enter their own wireless network name and password (no less than 8 digits), click "Connect."

Step Two: The router is connected to the Internet, please wait a moment!

Step three: Congratulations, now connected to the internet! click "Finish Setup." Jump to the D_link site, indicating that you can access the Internet.

II, DIR-890L, dir-880l, DIR-859, dir-850l (b), dir-868l (b), DIR-818LW and other routers

Important Note: This wizard interface is incompatible with the IE8 browser and the following version, if you are experiencing configuration problems, please upgrade IE version or use another browser to configure.

Router configuration:

Step One: The Setup Wizard interface appears and click Next.

Step two: Detect the type of Internet.

Note: If the test results for other online methods, you can click "Back" to choose the Internet mode of "Dynamic IP."

Step three: Set the name of the Wi-Fi wireless network, set the Wi-Fi wireless network password, and click Next.

Step four: Set the administrator password and click "Next".

Step Five: Please confirm that this page displays the information correctly, click "Next"

Note: It is recommended that the information on this page be recorded for later enquiries. This page records the Wi-Fi wireless name and password, and the device login password.

To display the Internet cannot connect:

1 First, please confirm that the network can be assigned to the normal address, you can directly connect with the computer broadband test.

2 can try to set up dynamic IP manually, please refer to: How to manually configure dynamic IP?

If there are other devices to connect the Internet router, wired computers only need to connect the computer to the router LAN port, wireless devices such as notebooks, mobile phones, pad only needs to find the wireless network name, enter the wireless password connection, you can directly access the Internet