Don't go to bed on the computer. What about WiFi?

The wifi sharing wizard is enabled successfully, and the mobile phone is connected.WiFiNo, but the network still shows the connection status. What is the problem? analyze the problem and solve the problem. Based on the information I collected, the answer is:

I. Analysis of the causes of this problem by the WiFi sharing genie:

1. In order to save power, the system will automatically turn off the NIC when the computer is not used for a period of time;

2. The computer may automatically sleep.

Ii. Solutions to this problem:

1. view the network card used by the WiFi sharing Wizard: Right-click the computer logo (Figure 1), select "Open Network and sharing center, and select" Change adapter Settings ", this shows a wireless network adapter in use (figure 2). Right-click and select properties, and you will see "Microsoft Virtual WiFi miniport adapter #2" (Figure 3 ), this is the wireless Nic service in use;

 

 

Figure 1

 

Figure 2

 

Figure 3

2. disable the enable/disable option of the NIC: Right-click the computer, select Properties, select "Device Manager" (figure 4), and select "network adapter" (figure 5 ), you can also see "Microsoft Virtual WiFi miniport adapter #2", right-click and select properties, and deselect "allow computer to close this device to save power" as shown in the figure (figure 6 );

 

 

Figure 4

 

Figure 5

 

Figure 6

3. In the face of the computer's automatic sleep, you just need to turn off the computer's automatic sleep. Right-click the power pattern in Figure 1, select the power option, select "change computer sleep time" (figure 7), and turn off the sleep time (figure 8 ).

 

 

Figure 7

 

Figure 8

Note: If you are using WiFi shared by the WiFi sharing genie, you may try the above solution if the network is disconnected. In addition to network fees, the above situations may exist. Of course, it may be that your cable bandwidth is in arrears. Haha!