DOS command interlnk, intersvr command usage instructions _dos/bat

[Usage] DOS new support network features,
It enables two computers to compose a simple network via a combined port or serial line
Use Interlnk must add a sentence in Config.sys:
Device=c:\dos\interlnk
Parallel to the end of the line should be 25-pin joints, the needle connection between the following figure: corresponding
P2------------------------P15
P3------------------------P13
P4------------------------P12
P5------------------------P10 Joint is a needle-carrying
P6------------------------P11 female connector is a hole
P15-----------------------P2
P13-----------------------P3
P12-----------------------P4
P10-----------------------P5
P11-----------------------P6
P25-----------------------P25 Ground

[Example] C:\dos\>interlnk port-lpt1
This Computer the other Computer
(Client) (Server)
----------------------------------------
E:equals A:
F:equals C:
In the client, e disk is the server a disk, F disk is the server C disk
Intersvr start a simple Web server
[Application] Use it, the computer becomes the server (only with DOS provided Simple network)
[Usage] intersvr start the service machine
Intersvr/lpt:1 starts the service machine, uses the LPT1 port as the data transmission port
Intersvr/com:1 starts the service machine, uses the COM1 port as the data transmission port
Parameters also have x baud:b v rcopy (see INTERLNK)
[Example] C:\dos>intersvrurl