Easy PHP + Mantis assembly and Setup

Easy PHP + Mantis installation and setup

1. Download easy PHP and MANTISBT programs

2, install easy PHP, start

If the report "Cannot open an existing program" What the error, download vs2005 and vs2008 run the package, very small, a few megabytes. I first installed the VS2005, after installation or can not start easy PHP Apache, and installed vs2008, this is good. So it's not clear if you just need to install vs2008.

3, the MANTISBT application is extracted into the easy PHP under the WWW folder, and then access to http://localhost; the page where the MySQL database is set up, the password is set, and then saved.

4, visit http://localhost again; Found two folders, one of which is the Mantis project, click to enter the login screen.

5. If other machines are inaccessible, check if the Conf configuration under Apache is set to 127.0.0.1, you can replace the 127.0.0.1 address that appears in the full-text with the IP address of the Setup program. And the port is an old problem, replace it with 80 port, other colleagues access to save input port number.

The general access address is: http://IP/mantisbt/login_page.php

6. Set Chinese display

config_defaults_inc.php Configuring the default settings for many mantis

Will $g_default_language = ' chinese_simplified ';

7, the displayed time and the current time are inconsistent

Set the time zone, the default time zone is set to empty

Date.timezone = ' PRC '

Or it can be modified by the page.

